Abstract:In this paper, the performance of the electronic conventional image motion compensation (IMC) method based on the time delay integration (TDI) mode was analyzed using the optical injection formula of charge coupled devices (CCDs). The result shows that the non-synchronous effect of charge packet transfer caused by line-by-line transfer during exposure makes the compensated image dissatisfying. Then an improved electronic IMC method based on the CCD multiphase structure was proposed. In this method, a series of proper driving clocks were applied to drive the charge packet to move electrode-by-electrode during the exposure time, which results in a minimum non-synchronous effect of charge packet transfer. The mismatch of velocity between charge packet transfer and image motion was decreased. The performance of the improved electronic IMC method was also analyzed using the optical injection formula. The modulation degrees of the two methods were compared. The average value of the modulation degree of the improved electronic IMC method was 47/96, greater than the conventional electronic IMC method, which was 1/3. To achieve the improved electronic IMC, the driver timing diagram of the improved electronic IMC method was proposed. This paper presented an improved hardware implementation method for the improved electronic IMC method. Based on the basic FTF4052M drive circuit system, an IMC pulse pattern generator that worked together with the main pulse pattern generator (SAA8103) was added to achieve the improved electronic IMC. Then, the internal structure of the IMC pulse pattern generator was given. A dual pulse pattern generator drive circuit system was proposed. After computer simulation and indoor real shot verification, the compensation effect of the improved electronic IMC method was better than the compensation effect of the conventional electronic IMC method.

Comprehensive Model of Modulation Transfer Function for Non-Ideal Charge-Coupled Devices

Evaluation of Subpixel Imaging Quantity of CCD Sensorbased on Modulation Transfer Function

Modulation transfer function measurement of charge-coupled devices using frequency-variable fringe patterns

MTF degeneration research of color CCD interpolation

Transverse Dynamic Modulation Transfer Function of Subpixel Push-Scanning Imaging by Linear CCD

Research on Modulation Transfer Function of the Electron Multiplying CCD

Distributed equivalent circuit model for the charge carrier multiplier of electron multiplying CCDs

Simulation for Signal Charge Transfer of Charge Coupled Devices

THE MODULATION TRANSFER FUNCTION OF LINEAR ARRAY CCD

Analytical Modeling of Charge Behavior in Pinned Photodiode for CMOS Image Sensors

Research on Model of Charge Delivering in CCM Based on Z Transform

MOS-based model of four-transistor CMOS image sensor pixels for photoelectric simulation

Modelling Charge Transport and Electro-Optical Characteristics of Quantum Dot Light-Emitting Diodes

Influencing Factors of Image Uniformity Affected by Output Probability Distribution of Charge Carrier Multiplier

Mechanism Analysis and Experiment Simulation on Radiation Effects of CCDs

Multiplication Model of EMCCD Based on Single Type of Carrier

An Improved Electronic Image Motion Compensation (IMC) Method of Aerial Full-Frame-Type Area Array CCD Camera Based on the CCD Multiphase Structure and Hardware Implementation

Charge Transfer Potential Barrier Model of a Pinned Photodiode in CMOS Image Sensors

Characteristics and Performance of Image Sensor Communication

The Analysis of the Total Transfer Efficiency of the Charge Packet in a TDI-CCD Image Sensor

Modeling of Photodiode for CMOS Image Sensor