Abstract:Performance of a conventional phase detector implemented using analog circuitry is affected by, among other factors, the parameter value drifting of the analog components with environment (e.g., temperature) and time (i.e., aging). It is also adversely impacted by electromagnetic interferences likely existing in the analog circuits when the detector operates in a high frequency range. More importantly, such a detector is inflexible to compensate various nonlinear characteristics of sensors and is very difficult to realize sophisticated signal processing strategies desired for practical applications. To address issues like these, we have developed a digital system approach that uses the zero-crossing algorithm for phase detection. The phase detection limit and dynamic phase response of the system were assessed using surface acoustic wave (SAW) sensors. Our preliminary evaluation involved AlN dual-mode differential sensors, which were fabricated on an AlN(0001)/Al2O3(11 2 ¯ 0) thin film structure, with the SAW and shear horizontal SAW (SH-SAW) operating at approximately 243 MHz and 256 MHz, respectively. Due to the hardware constraints, the digital phase processing was carried out in an off-line fashion. Our baseline experiments without sensor indicate that the system can achieve a lower level of phase noise with the standard deviation being about 0.005°. Experiments with the differential sensors running in the SAW and SH-SAW modes exhibit that the system can reach a phase detection limit of 0.02°. The differential system showed small temperature coefficient at ppm level measured by varying the sensor temperature using a thermal control oven. Finally, our use of the system in measuring the response of the SH-SAW sensor to sodium chloride (NaCl) solution conductivity shows that the system is capable of performing microanalysis of liquid properties. We conclude that a real-time fully digital phase detection system can be practically achieved.

Differential Phase Measurement With External Trigger

Phasemeter With External Trigger Applied To Pzt-Modulated Interferometer

Pulsed Light Time-of-flight Measurement Based on a Differential Hysteresis Timing Discrimination Method.

FPGA-based Control Method for Rotor Vibration Signal's Full Cycle and Equal Phase Sampling

Method and System for Phase Measurement of the Heterodyne Interference System

Real-time Phase Difference Measurement Method with FPGA Speeding Up

Compensating Trigger Jitter and Time Interval Error Measurement for Digital Sampling Oscilloscopes with Hardware Design on FPGA

Signal Phase Detection of Equal Accuracy

A Multi-Channel Digital Programable Delay Trigger System with High Accuracy and Wide Range

High-precision Phase Detection in Femtosecond Timing and Synchronization System for TXGLS

A PM-based Approach for Doppler Frequency Shift Measurement and Direction Discrimination

Method of Fiber Transfer Delay Measurement Based on Phase Quantization and Delay Synthesis

A relative frequency difference detection method based on TDC

A beam phase and energy measurement system based on direct RF signal IQ under-sampling technology

Measurement and Control from Frequency to Phase Based on Virtual Signal Reconstruction.

Simulation Analysis of Phase Jitter in Differential Sampling of AC Waveforms Based on the Programmable Josephson Voltage Standard

A Beam Phase and Energy Measurement Instrument Based on Direct RF Signal IQ Undersampling Technique

Prototype development of a three-stage, high-precision, low-jitter, wide-range digital delay generator fully utilizing on-chip resources

Novel Phase Detector Measurement Procedure Using Quasi-Synchronized RF Generator

Design of the waveform distinction algorithm for the main drift chamber at the Super Tau-Charm facility

Digital phase detection approach and its application for AlN dual-mode differential surface acoustic wave sensing