Abstract:Modern high-energy particle accelerators and free-electron lasers incorporate large quantities of sensitive RF and microwave devices distributed over several kilometers. Such devices require extremely stable phase and time synchronization by means of high-frequency signals distributed along the accelerator facility. Coaxial cables are frequently used to distribute the reference signal over the large machine to synchronize electronic systems. These cables are the main source of undesirable phase drifts in the synchronization system. Signal phase drifts in cables are mainly caused by temperature and humidity variations and their values usually exceed required phase synchronization accuracy by more than an order of magnitude. Air pressure can also influence on the signal phase drifts but with a much smaller impact than from temperature and humidity changes. There are several approaches to reduce signal phase drifts in coaxial cables. This article describes the realization of an active phase stabilization system based on the interference phenomenon. A phase-locked signal from the transmitter is reflected at the end of a coaxial cable link. Directional couplers placed along the cable pick up the forward and reflected signals and interfere them to cancel out the cable phase drifts. Distributed hardware, including interferometer controller/transmitter and receiver modules, was built to demonstrate the system concept and performance. FPGA I/O boards with an Ethernet interface are used to control the system operation. Specialized firmware and software were developed to calibrate and control the system. This article describes the concept of the interferometer link, the designed hardware, basic control algorithms, and performance evaluation results. A prototype of the link was built to distribute a 1.3-GHz signal through a coaxial cable. Measured values of the phase drift suppression factor exceeded the level of 100.

High-precision Phase Detection in Femtosecond Timing and Synchronization System for TXGLS

Development of Sub-100 Femtosecond Timing and Synchronization System.

Laser–RF Synchronization Based on Digital Phase Detector

Fs-Level Laser–rf Synchronization with a Fiber-Loop Optical-Microwave Phase Detector

A beam phase and energy measurement system based on direct RF signal IQ under-sampling technology

Synchronization and control system for tsinghua thomson scattering X-ray source

Precise Control and Measurement of Laser–RF Synchronization for Thomson-scattering X-ray Source

Timing and Synchronization diagnostics of Thomson scattering X-ray source

Phase Drift Compensating RF Link for Femtosecond Synchronization of E-XFEL

High-precision Distribution of Highly-stable Optical Pulse Trains with Sub-10-fs Timing Jitter

Design and Implementation of FPGA-based High-speed Phase Detector in Single-frequency Laser Interferometer

A Beam Phase and Energy Measurement Instrument Based on Direct RF Signal IQ Undersampling Technique

Application of a Drift Compensation Low-Level Radio Frequency System Based on Time-Multiplexing Pick-Up/reference Signals

A High-Precision 2.5-Ps RMS Time Synchronization for Multiple High-Speed Transceivers in FPGA

Synchronization System for Tsinghua Thomson Scattering X-ray Source

High Time Resolution Beam-Based Measurement of the Rf-To-Laser Jitter in A Photocathode Rf Gun

Compact single-shot electro-optic detection system for THz pulses with femtosecond time resolution at MHz repetition rates

A 3.8 ps RMS time synchronization implemented in a 20 nm FPGA

Ensuring Grid Synchronization with Pulsar Timing: Novel Analog Front-End Circuit and Pulse Extraction Framework

Design and Development of Laser-Rf Synchronization System for Thomson-scattering X-ray Source at Tsinghua University

Timing System Based on Customized Frequency White Rabbit Network in SHINE