Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

FPGA-based Control Method for Rotor Vibration Signal's Full Cycle and Equal Phase Sampling

Design of Vibration Signal’s Multi-channel Integer Period Synchronous Acquisition Card

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

Research on Control Accuracy at Low Frequency in Vibration Test

Power Spectra Density Replication Control Strategy for 2-Axis Hydraulic Shaker Based on HV Estimator

Control Designs for Multi-Exciter Power Spectral Density Replication Vibration Tests

Afull Period Sampling Method Based on the Application of Resampling Technology

A Fast Vibration-Level Adjustment Method for Low-Frequency Vibration Calibration Based on Modified Filtered-X Least Mean Square Algorithm

Mode Matching-Based Vibration Signal Full Period Sampling Method in Rotation Machinery

Virtual Variable Sampling Repetitive Control of Single-Phase DC/AC PWM Converters

Design and Implementation of the Digital Detection Circuit for RFOG Based on a Single FPGA

Constant-frequency Oscillation Control for Vibratory Micro-Machined Gyroscopes

Exploration of Vibration Signal Measurement Method of Automobile Parts Utilizing FPGA/Photoelectric Sensor

Design And Implementation Of Integral Period Sampling For The Multi-Channel Vibration Signals

Design of multi-channel synchronization signal acquisition method based on FPGA

Fpga-Based Expanded Circuit Design for Dsp Signal Processing

Self-sensing active magnetic bearing using Hilbert transform

Expanded Circuit Based on FPGA for DSP Signal Processing in Electromagnetic Bearing Systems

Research on PSD Replication for Multiaxial Hydraulic Vibration Test System Based on FXLMS Algorithms

Variable Frequency Driver System of Asynchronous Motor Based on FPGA

High frequency signal acquisition and control system based on DSP+FPGA