Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

Afull Period Sampling Method Based on the Application of Resampling Technology

Mode Matching-Based Vibration Signal Full Period Sampling Method in Rotation Machinery

FPGA-based Control Method for Rotor Vibration Signal's Full Cycle and Equal Phase Sampling

The Application of Adaptive FFT Power Spectrum Analysis in the Vortex Flowmeter

Research on Control Accuracy at Low Frequency in Vibration Test

Broadening Frequency Response of Distributed Sparse- Wideband Vibration Sensing Via Time-Division Multifrequency Sub-Nyquist Sampling

A New Algorithm for Sine on Random Vibration Test Based on Multirate Spectrum Estimation

Sine-On-Random Vibration Test Based On Multi-Resolution Spectrum Estimation And Wiener-Khinchin Theorem

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

Design of Vibration Signal’s Multi-channel Integer Period Synchronous Acquisition Card

The Analysis of Optimal Sampling Period on Output Multi-Rate Predictive Control System

Design And Implementation Of Integral Period Sampling For The Multi-Channel Vibration Signals

Application of State-Space Partitioning Method in Power System Reliability Assessment

A New Method for Non-Uniform Under-Sampled Blade Tip Timing Signal Reconstruction

Analysis of optimal sampling period based on multi-rate predictive control systems

The Application of Multisampling in APF Digital Control

Research on non-synchronous sampling errors in electric power system

Time-Based Finite-Rate-of-Innovation Sampling for Variable-Pulse-Width Signal

An Identification Method for Multirate Sampled-Data Systems Based on Wavelet Multiresolution Analysis

Fault Detection for Dynamic Systems Based on Multirate Sampling

Improved Synchronous Sampling and Its Application in High-Speed Railway Bearing Damage Detection