Abstract:Dry sliding wear tests and corresponding particulate matter (PM) analysis were conducted on a newly developed SiC-graphite-based composite friction material, paired with two types of HVOF counterface/discs: WC-CoCr and WC-FeCrAlY coatings, with a conventional martensitic stainless steel counterface as a reference. The trials were conducted on a pin-on-disc testing equipment at room temperature and a constant sliding velocity and contact pressure of 7 m/s and 0.5 MPa, respectively. The coefficient of friction (CoF) curves with the uncoated disc exhibited considerable fluctuations. On the other hand, the coated discs featured an increase in the CoF at the beginning of the tests, followed by either a continuous reduction until the end of the testing duration or the attainment of a steady state regime. The pin wear and emissions with both coatings were appreciably lower when compared to the trials with the uncoated disc. The evaluation of the friction layer observed a significant contribution of the counterface for all the pairings. The PM analysis was conducted on the particles that were lying in the range of 10 μm and 2.5 μm on a scanning electron microscope (SEM), and particles from 2.5 μm and 1 μm on transmission electron microscope (TEM), with an emphasis on the particles that were detached from the pin surface and friction layer to explain the wear mechanisms for each pairing. Through this, the need for the proper selection of both friction material and counterface to avoid the emission of harmful compounds in the environment was highlighted.

SEM and SEAM study on tribological performance of cermets coatings

Research On Wear Behavior Of Atc Cermet Material

Microstructure, Mechanical and Tribological Properties of CrSiC Coatings Sliding Against SiC and Al2O3 Balls in Water

Tribological Behavior of Various Plasma-Sprayed Ceramic Coatings

In-situ friction and wear study of SiCα/SiCβ and Al2O3-TiC-Co composite ceramics

Microstructure, Mechanical, and Tribological Properties of Cr-Ti-Si-N Coatings

Effect of MoS2/PTFE coatings on performance of Si3N4/TiC ceramics in dry sliding against WC/Co

Tribological characteristics of WC-Cr3C2-Ni cermet coatings under different wear parameters

Comparisons of tribological and electrochemical properties of CrSiC and CrSiCN coatings in seawater

Comparative tribological performance of a-C:H, ta-C and AlCrSiN coatings on 20CrMnTi gear steel under dry sliding condition

An investigation of fretting wear behaviors of bonded solid lubricant coatings

Tribological performance of Mn3(PO4)2 coating and PC/MoS2 coating in Rolling–Sliding and pure sliding contacts with gear oil

Friction and wear performance of CrSiBCN coatings sliding against ceramic and metal counterparts in sea water

A comparative analysis of different surface tribological and electrochemical properties of TiAlN, TiAlSiN, and CrAlN thin film coatings in seawater

The Dry Sliding Wear Behavior of HVOF-Sprayed WC: Metal Composite Coatings

Tribological behavior of aluminum matrix composites reinforced with ceramic particulates in dry sliding against a semimetallic friction material

Study on Plasma Sprayed 40%Zro_2-Al_2o_3-13%tio_2 Ceramic Coatings and Tribological Properties

Study on salt spray corrosion and friction wear performance of CrN coated cemented carbide sealing ring

Friction and wear properties of CrSiCN coatings with low carbon content as sliding against SiC and steel balls in water

FRICTION AND WEAR PERFORMANCE OF AN ELECTROSPARK-DEPOSITED Ta COATING ON CrNi3MoVA ST

Dry Sliding Behavior and Particulate Emissions of a SiC-graphite Composite Friction Material Paired with HVOF-Coated Counterface