Abstract:<p>This study considers the factors controlling the grain structure of commercially pure aluminum when a Pulsed Magnetic Field (PMF) is applied during solidification. It is revealed that PMF of pure metal forms equiaxed grains by different nucleation and growth mechanisms depending on the casting conditions. One mechanism occurs when PMF is applied from above the melting point. On reaching the melting point copious nucleation occurs on the mold walls and these small grains are detached by pulses occurring every 100 milliseconds. Convection due the PMF generated Lorenz force distributes the grains in the melt resulting in a refined equiaxed grain structure throughout the casting. Another mechanism is nucleation of the columnar grains that form a shell on the walls of the mold before PMF is applied and once applied fluid-solid coupling develops due to the Lorenz force. Depending on the shell thickness, this fluid-solid coupling detaches the columnar shell or, for thicker shells, only the top few millimeters of the shell from the mold wall. The detached shell is then fragmented into large blocky grains due to a lower melting point iron-rich liquid phase on the grain boundaries. In this case a bimodal grain structure is produced because the exposed wall generates fine grains as described above filling the gaps between the large blocky grains. The optimal condition for uniform refinement is when PMF is applied from above the melting point ensuring that a refined equiaxed grain structure forms throughout the casting.</p>

Relationship Between Solid Fraction and Distribution of Pb in Al-Pb Ingot

Influence of Pb doping on superconductivity of α-BiPd and β-Bi2Pd alloys

The Behavior of Lead During the Solidification of Zn–0.1Al–0.1Pb Coating on Batch Hot-Dipped Steel

Solubility after Mechanical Alloying for Al-Pb Immiscible Alloy System

The effects of Bi and Pb on the soft phase in Al82Sn15Si2.2Cu0.8 sliding bearing alloy

Superheating and Melting-Point Depression of Pb Nanoparticles Embedded in Al Matrices

Experimental and Numerical Study on the Formation of Channel Segregation in Pb-Sn Alloy Ingot

Influences of Master Alloys and Their Preparation Conditions on Microstructures of Semi-solid A356 Alloy Slurries

Melting of embedded Pb nanoparticles monitored using high-temperature in situ XRD

Microstructure and Morphology of Al-Pb Bearing Alloy Synthesized by Mechanical Alloying and Hot Extrusion

Study on Phase Transformation and Thermodynamic and Kinetic of Al-Pb Powder During Mechanical Alloying

Effects of Pouring Temperature on Solidification Behavior of Aluminum Alloy Melt with Electromagnetic Stirring

The Effect of Cu Addition and Milling Contaminations on the Microstructure Evolution of Ball Milled Al–Pb Alloy During Sintering

Heterogeneous Coarsening of Pb Phase and the Effect of Cu Addition on It in a Nanophase Composite of Al–10wt%Pb Alloy Prepared by Mechanical Alloying

Effect of Cu Particles on the Properties of Sn-Bi-Pb Low-Melting-Point Alloys

Microstructure Analysis for Al-Pb Alloy of Preparation in Powder Metallurgy Processing

Mechanical alloying of immiscible Pb-Al binary system by high energy ball milling

Revealing the Mechanisms for the Nucleation and Formation of Equiaxed Grains in Commercial Purity Aluminum by Fluid-Solid Coupling Induced by a Pulsed Magnetic Field

Relationship of Compositions, Phase Constituents and Solidification Paths of Casting Mg-Al-Zn Alloys

Study On Aluminum Alloy Semi-Solid Billets Prepared By Electromagnetic Stirring Process

Impurity distribution in preparation of high-purity aluminum by vacuum zone melting