Abstract:In this paper, a modeling method based on MATLAB/Simulink for a temperature-dependent SiC MOSFET in the entire working region was proposed. Using a supplementary test circuit, the output characteristics of a device in the saturated region were extracted. Based on these characteristics, the model covered the output characteristics of the device in the whole working region. From the output curves, three main parameters essential for modeling were derived. Based on the Si lateral double-diffused MOSFET model, a temperature-dependent static model of SCT20N120 was established by adding a temperaturedependent compensation voltage source to simulate the temperature characteristics of the threshold voltage and a temperature-dependent compensation current source to compensate for the drain current error in the linear region due to the differences in structure and material between Si and SiC. In addition, based on the gate equivalent circuit, the dynamic model of the target device was established. The temperature-dependent static simulation results could simulate the actual measured values well. Furthermore, based on the comparison between the dynamic simulation results involving the device's turn-on and turn-off process losses and the actual transient state losses derived from a double-pulse test under the conditions of Vds = 300 V, Id = 15 A, Rg_exton = 18 Ω, and Rg_extoff = 12 Ω at 200 °C, the maximum error was 6.7%.

Characterization Method for Proportional Difference Characteristic of MOSFET Devices

An Accurate Relationship for Determining the Key Parameters of MOSFETs by Proportional Difference Operator Method

Proportional difference operator method and its application to studying the saturation characteristics of MOSFETs

An Improved RF MOSFET Model Accounting Substrate Coupling among Terminals

Proportional Difference Method for Determination of the Threshold Voltage and the Effect Inversion Carrier Mobility of an MOSFET

Determination of threshold voltage and mobility of MOSFET by proportional difference operator

New Method for Extraction of MOSFET Parameters

Linear Cofactor Difference Extrema of MOSFET's Drain–Current and Application to Parameter Extraction

Refined Electrical Modelling of Power MOSFETs Based on Physical Information

Linear Cofactor Difference Extrema of Mosfet'S Drain Current and Their Application in Parameter Extraction

Application of the proportional difference time analysis to study carrier generation rate in MOS structures

Analytic MOSFET surface potential model with inclusion of poly-gate accumulation, depletion, and inversion effects

Normalized mutual integral difference operator: A novel experimental method for extracting threshold voltage of MOSFETs

A rigorous analytical model for short-channel junctionless double-gate MOSFETs

An Analytic Model for Channel Potential and Subthreshold Swing of the Symmetric and Asymmetric Double-Gate MOSFETs

An explicit surface potential model of bulk-MOSFETs with inclusion of poly-gate accumulation, depletion, and inversion effects

A Non-Charge-Sheet Analytic Model for Symmetric Double-Gate MOSFETs With Smooth Transition Between Partially and Fully Depleted Operation Modes

Threshold Voltage Of Mosfet Devices Extracted By Normalized Mutual Integral Difference Operator

A complete surface potential-based core model for undoped symmetric double-gate mosfets

A Temperature-Dependent SiC MOSFET Modeling Method Based on MATLAB/Simulink

A Rigorous and Concise Surface Potential-Based Core Model for the Undoped Symmetric Double-Gate Metal-Oxide-Semiconductor Field Effect Transistors