Abstract:Key effects of solvent formulations on the structure and morphology of optical-quality yttrium-aluminum nanocomposites using liquid-fed aerosol flame synthesis are investigated. Employing a temperature-controlled flat flame burner with inexpensive nitrates as multi-component precursors, three different solvent formulations, i.e., ethanol, ethanol/2-ethylhexanoic acid (EHA), and butanol, are studied. Adding EHA into ethanol in a 1:1 volume ratio dramatically changes the flame-made yttrium-aluminum oxides from hollow inhomogeneous powders that contain non-uniform large particles to homogeneous nanopowders around 10 nm. As characterized by in-situ phase Doppler anemometry, droplet size with increasing burner height for the EHA/ethanol case remains constant at the beginning, whereas those for both ethanol and butanol cases reduce immediately. EHA likely causes a shift from the droplet-to-particle precipitation route to the gas-toparticle route because of the formed low-boiling-point 2-ethylhexanoates from nitrates via ligand exchange. By replacing ethanol with butanol, hollow particles are produced with better crystallinity because of its high calorific value that helps to heat precursors at the droplet surface. In-situ diagnostics using phase-selective laser-induced breakdown spectroscopy, which tracks only atomic emission from the nanoparticle phase. The result shows that the Al atomic emissions in the EHA/ethanol mixture case gradually increase along the burner height, while those for both ethanol and butanol cases fluctuate, further verifying the favoring of the gas-to-particle route for producing uniform, ultrafine solid multi-oxide particles by adding EHA in solvents. (C) 2018 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

Investigation of the Process of Synthesizing ZrO2 Nanoparticles by Heating of Alcohol-Aqueous Salt Solutions

Nano ZrO2 (Y2O3) Particles Processing by Heating of Ethanol–aqueous Salt Solutions

Synthesis of yttria-stabilized zirconia nanoparticles by heating of alcohol-aqueous salt solutions

Synthesis, Densification and Characterization of Nanosized Oxide Ceramic Powders with Eutectic Compositions by Heating of Alcohol-Aqueous Salt Solutions

Synthesis of Single-Crystalline Pb(Zr0.52Ti0.48)O-3 Nanocrystals by Hydrothermal Method

Compacting and Sintering Behavior of Nano ZrO 2 Powders

Preparation of Zirconia Powders by Sol-gel Process

Supercritical Hydrothermal Synthesis of Nano-Zro2: Influence of Technological Parameters and Mechanism

Preparation and Characterization of Alumina-Zirconia Nanoparticles

Fine-tuning the Synthesis of ZnO Nanostructures by an Alcohol Thermal Process.

Synthesis of Yttrium Oxide Nanocrystal Via Solvothermal Process

Hydrothermal Synthesis and Characterization of Zirconia Nanocrystallites

From Gel to Crystal: Mechanism of HfO2 and ZrO2 Nanocrystal Synthesis in Benzyl Alcohol

Investigation on the Preparation and Properties of Monodispersed Al2O3ZrO2 Nanopowder Via Co-precipitation Method

Solvent Effects on the Solvothermal Synthesis of PureMonoclinic and Tetragonal Zirconia Nanoparticles

Co-precipitation of nano Mg–Y/ZrO2 ternary oxide eutectic system: Effects of calcination temperature

PREPARATION OF ZrO2(n)-Al2O3 CERAMIC NANOCOMPOSITE BY MIXING SOL WITH AQUEOUS SUSPENSIONS

Preparation and characterization of nano-scale Y2O3-ZrO2 powder by heterogeneous precipitation

ZrO2 Nanoparticles Synthesized by the Sol–Gel Method: Dependence of Size on pH and Annealing Temperature

Characterization of the Near-Eutectic Al2O3–40 Wt% ZrO2Composite Coating Fabricated by Atmospheric Plasma Spray. Part I: Preparation and Characterization of Nano Al2O3–ZrO2Powder Using Sol–Gel Method

Investigating the role of solvent formulations in temperature-controlled liquid-fed aerosol flame synthesis of YAG-based nanoparticles