Abstract:In the process of large aspheric optical surfaces fabrication, the distortion of the removal function is a big problem that affects the producing efficiency and accuracy, due to the misfit between the tool and the aspheric surface in the contact region. Consequently, this paper aims to find out the influence factors and the distortion rule of aspheric removal function in the computer-controlled optical surfacing. Firstly, based on the analysis of the sub-aperture polishing technology for the large aspheric optical surfaces, the local asphericity of aspheric surface and the viscoelasticity of polishing tool are supposed to be the main sources. After that, a method to calculate the local asphericity considering the misfit between the tool and the aspheric surface is proposed based on the least square method, and the viscoelasticity of the polishing tool is obtained through viscoelastic experiment. Subsequently, combining the results of the local asphericity of aspheric surface and the viscoelasticity of polishing tool, the prediction of the distortion rule of aspheric removal function is presented. Finally, the comparative experiment is carried out, and the removal function on different regions of the aspheric surface is obtained. The experimental result indicated that the distortion of the removal function is consistent with the theoretical result. Through this study, the distortion rule of aspheric removal function in the computer-controlled optical surfacing with pitch tool is finally mastered, which provides a theoretical guidance for the computer-controlled optical surfacing process optimization.

Correcting the Accuracy of Non-Rotating and Aspheric Lens by Controlling the Pressure of the Polishing Die

Misalignment Correction for Free-Form Surface in Non-Null Interferometric Testing

Distortion Correction in Surface Defects Evaluating System of Large Fine Optics

Retrace Error Correction for Non-Null Testing of Optical Aspheric Surface

A Framework of Cooperative Design for Aspheric Glass-Lens Mold

Research on Computer Controlled Optical Surfacing (CCOS) Working Function at Wear State

Research of precision interference locating method for a partial null compensator at aspheric testing

Development of Ultra-Precision Grinding Process for Aspheric Surface Based on Feed Rate Controlling and Error Compensation Methods

Error Compensation in One-Point Inclined-Axis Nanogrinding Mode for Small Aspheric Mould

Computer-controlled Compensation for Wearing of Polishing Head

Processing Flow of Optical Fabrication for Correcting Lenses

Tilt angle correction based forming algorithm for high steepness aspheric surfaces polishing

Distortion of Removal Function Based on the Local Asphericity of Aspheric Surface and the Viscoelasticity of Polishing Tool in Computer-Controlled Optical Surfacing

Correction For Mapping Errors In Non-Null Test Of Aspheric Surface

Pressure-Based Grinding and Polishing of Free-Form Lenses with Spherical Tools

Optimization of Removal Function Parameters in CCOS

Correction of remounting errors by masking reference points in small footprint polishing process.

Practical Retrace Error Correction in Non-Null Aspheric Testing: A Comparison

Modelling and Simulation of Mid-Spatial-frequency Error Generation in CCOS

Research and application on the key techniques of conformal vibration polishing on optics

Edge Control in the Computer-Controlled Optical Surface