Abstract:In this paper, the metal oxide is determined according to the characteristics of the very fast transient overvoltage (VFTO) waveform measured in the gas-insulated metal-enclosed switchgear (GIS) according to the standard regulations. The waveform parameters of the metal oxide varistor (MOV) test platform were designed to build pulse generators with 8μs, 100ns and 20ns wave-heads. Several typical MOVs for 110kV and 220kV system arresters were selected as samples. The impedance characteristics and response characteristics of MOV under the pulse of the above three different wave-head times are studied. The experimental results show that under the pulse of 8μs and 100ns with different amplitudes, the MOV voltage reaches the peak value and shows the inductance characteristics. The MOV under 20ns pulse shows different impedance characteristics. There is an impedance characteristic transition voltage U 0 , and at U 0 voltage, the MOV shows resistivity. When the voltage peak on the MOV is less than U 0 , the current reaches the peak before the voltage, and the MOV mainly shows the capacitance characteristic. When the voltage peak on the MOV is greater than U 0 , the voltage reaches the peak before the current, and the MOV mainly shows the inductance characteristic. Under 8μs pulse, the time when the voltage and current on the MOV reach the peak value differ by 2.4μs; Under 100ns pulse, the time when the voltage and current on the MOV reach the peak value differ by 1μs; Under 20ns pulse, the time when the voltage and current on the MOV reach the peak value differ by less than 11ns. The shorter the wave-head time of the pulse, the smaller the difference between the time of the voltage and current peak value.

The Influence of Varistor Disk Capacitance of MOV Arrester on Its Voltage Distribution

Study on the Potential Distribution of Grading Capacitor Column in UHV MOA Without Gaps

The Statistic Analysis on Principal Electric Parameters of MOV for Surge Arrester

Electric Field Analysis of 500 Kv Tank Type Metal Oxide Surge Arresters

Analysis and Improvement of Potential Distribution of 1000-Kv Ultra-High-Voltage Metal–Oxide Arrester

Finite Element Calculation and Experiment of Potential Distribution for a 500 kV Porcelain Zinc Oxide Arrester

Investigation into the Equivalent Circuit of MOV and the Determination of Its Parameters

Influence of Grading Ring on Potential Distribution of 1000 Kv Gas Insulted Switchgear Metal Oxide Arrester

The Analysis of Equivalent Circuits of Metal Oxide Surge Varistor under Different Surge Currents

Potential Distribution Analysis And Improvement Of 1000 Kv Gas Insulted Switch Metal Oxide Arrester

A Novel Capacitance Determination Method of Metal Oxide Arrester Blocks when Excited by VFTO

Study on Current Sharing Characteristics of Arrester for UHV DC

Analysis and improvement of potential distribution of 1000-kV metal oxide arrester by combining 3D FEM and circuit analysis method

Study of Voltage Distribution and Radial Electric Field under Different Pollution Conditions of 500kv MOA

Electrical-Thermal Failure of Metal–Oxide Arrester by Successive Impulses

Numerical Analysis Of The Influence Of Splitter-Plate Erosion On An Air Arc In The Quenching Chamber Of A Low-Voltage Circuit Breaker

Potential relation between resistors and porcelain in 1000kVMOA

Impedance Characteristics of Metal Oxide Varistor under Different Pulses

Behavior Comparison of Metal Oxide Arrester Blocks when Excited by Vfto and Lightning

Study of Potential Distribution of UHV AC Arrester in Different Conditions

Calculation of Electric Potential and Field Distribution of UHVDC Bus Bar MOA