Abstract:The minority-spin Fe/MgO interface states are at the Fermi level in density functional theory (DFT), but experimental evidence and GW calculations place them slightly higher in energy. This small shift can strongly influence tunneling magnetoresistance (TMR) in junctions with a thin MgO barrier and its dependence on the concentration of Co in the electrodes. Here, an empirical potential correction to DFT is introduced to shift the interface states up to match the tunnel spectroscopy data. With this shift, TMR in Fe/MgO/Fe junctions exceeds 800% and 3000% at 3 and 4 monolayers (ML) of MgO, respectively. We further consider the effect of alloying of the Fe electrodes with up to 30% Co or 10% V, treating them in the coherent potential approximation (CPA). Alloying with Co broadens the interface states and brings a large incoherent minority-spin spectral weight to the Fermi level. Alloying with V brings the minority-spin resonant states close to the Fermi level. However, in both cases the minority-spin spectral weight at the Fermi level resides primarily at the periphery of the Brillouin zone, which is favorable for spin filtering. Using convolutions of $\mathbf{k}_\parallel$-resolved barrier densities of states calculated in CPA, it is found that TMR is strongly reduced by alloying with Co or V but still remains above 500% at 4 ML of MgO up to 30% of Co or 5% V. At 5 ML, the TMR increases above 1000% in all systems considered. On the other hand, while TMR declines sharply with increasing bias up to 0.2 eV in the MTJ with pure Fe leads, it remains almost constant up to 0.5 eV if leads are alloyed with Co.

Microstructure Investigation of Fe/Al2o3/Fe Tunneling Junction

Investigation of Microstructures in a Fe/Al2O3/Fe Tunneling Junction Prepared Using the Ion-Beam Sputtering Technique

STUDING ON ELECTROMAGNETIC CHARACTERS OF Fe/Al2O3/Fe TUNNE LING JUNCTIONS

Interfacial Composition and Microstructure of Fe3o4 Magnetic Tunnel Junctions

40% Tunneling Magnetoresistance after Anneal at 380 °C for Tunnel Junctions with Iron-Oxide Interface Layers

Annealing Effect of Magnetic Tunnel Junctions with One Feox Layer Inserted at the Al2o3/Cofe Interface

Microstructure of Annealed Magnetic Tunnel Junction by Electron Microscopy

Study of MR in Fe/sub 3/O/sub 4/ tunnel junctions

Study in the Tunneling Junction of the NiFe/Al2O3/NiFe and NiFe/ Al2O3/CoFe Giant Magneto Resistance Effect

The Effect of Substrate Temperature on the Microstructure and Tunnelling Magnetoresistance of FeCo–Al 2 O 3 Nanogranular Films

Thermal Stability of Ir-Mn∕Co-Fe-B∕Al-O∕Co-Fe-B Tunnel Junctions

Inverse and Normal Tunneling Magnetoresistance Effects in Fecogd/Feco/Alo/Feco Multilayers

The research of the fabrication of Al/Al_2O_3/Al superconductor tunnel junctions by electron beam vapour

Magnetization Reversal Mechanism of Magnetic Tunnel Junctions

Nanoparticle morphology in FeCo–Al2O3 granular films with tunneling giant magnetoresistance

Effect of Anti-Diffusion Oxide Layer on Enhanced Thermal Stability of Magnetic Tunnel Junctions

Tunneling magnetoresistance in MgO tunnel junctions with Fe-based leads in empirically corrected density functional theory

Intermixing of iron and cobalt with oxygen-rich magnesium oxide in CoFeB/MgO/CoFeB magnetic tunneling junctions

Dependence of Giant Tunnel Magnetoresistance of Sputtered CoFeB/MgO/CoFeB Magnetic Tunnel Junctions on MgO Barrier Thickness and Annealing Temperatur

Tunnel magnetoresistance in alumina, magnesia and composite tunnel barrier magnetic tunnel junctions

Microstructural evolution of Fe/Ti multilayers submitted to in situ thermal annealing