Abstract:The quality of injection molded polymer products can be compromised due to the occurrence of residual stresses inherent to the molding process. In order to determine the parameters that influence the dimensional changes and residual stresses of injection molded polypropylene; computer simulations, chemical, thermal and mechanical characterizations were performed. Statistically, we evaluated two conditions of part geometry (with and without rib), three holding pressures (25, 60 and 96 MPa) and three post-molding conditions (without restriction, with restriction followed by water, and with restriction followed by annealing). The specimens molded with ribs and lower holding pressures showed greater warpage, which agreed with the computer simulations. The smooth specimens submitted to annealing followed by air cooling showed lower warpage in relation to the other two post-molding conditions. The thermal analysis presented a lower degree of crystallinity in the samples without post-molding restrictions. The samples submitted to the annealing heat treatment showed an increase in impact strength, and there was no significant variation in the modulus of elasticity for the post-molding conditions evaluated. The ribbed specimens exhibited higher residual stresses than the smooth specimens. Samples with greater warpage had lower residual stresses. All samples showed a tensile-compression-tensile behavior along the hole depth. The results showed that the shrinkage values were not influenced by any of the parameters evaluated. However, on the warpage the factor that exerts the greatest influence is the geometry of the part, followed by the holding pressure; and the post-molding condition presented the least influence among the analyzed factors.

Study on the Warpage of Plastics Vacuum-Forming Process

Experimental Study on Warpage Phenomenon of Wax Parts Manufactured by Fused Filament Fabrication

The Study of Controlled Cooling Technology and Warping of X65 Heavy Pipeline Plate

Residual stresses, shrinkage, and warpage of complex injection molded products: Numerical simulation and experimental validation

A Predictive Parameter for the Shape Memory Behavior of Thermoplastic Polymers

Simulation and Experimental Analysis on Non-circular Cross-section Parts Residual Wall Thickness of Water-assisted Injection Molding

3D Simulation of Residual Thermal Stress and Shrinkage in Plastic Injection Molding

Mold modification methods to fix warpage problems for plastic molding products

Analysis of the Warpage Phenomenon of Micro-Sized Parts with Precision Injection Molding by Experiment, Numerical Simulation, and Grey Theory

Warpage analysis and optimization of thin-walled injection molding parts based on numerical simulation and orthogonal experiment

A Study on Process-Induced Warpage of Curing Mold of Composite Structures

Influence of mold design and injection parameters on warpage deformation of thin-walled plastic parts

Warpage control method during surface forming process of plastic film‐reinforced flexible decorative veneer

Influence of process parameters and post-molding condition on shrinkage and warpage of injection-molded plastic parts with complex geometry

Simulation of Warpage and Mold Flow in the LFT-D Process

Macro-effect of process parameter on waspage of rapid heat cycle molding plastic part

Research on Lightweight Injection Molding (CAE) and Numerical Simulation Calculate of New Energy Vehicle

Theoretical and Experimental Investigation of Warpage Evolution of Flip Chip Package on Packaging during Fabrication

Experimental investigation of warpage in thin CF/PEKK composite laminates consolidated under non-isothermal conditions

A viscoelastic–viscoplastic modeling approach for amorphous polymers in vacuum forming simulation

Experimental and numerical investigations on thermoforming of thermoplastic prepregs of glass fiber reinforced nylon 6