Abstract:During the production of fiber-reinforced plastics using resin transfer molding (RTM), various characteristic defects and flaws can occur, such as fiber displacement and fiber waviness. Particularly in high-pressure RTM (HP-RTM), fiber misalignments are generated during infiltration by local peaks in the flow rate, leading to a significant reduction in the mechanical properties. To minimize or avoid this effect, the manufacturing process must be well controlled. Simulative approaches allow for a basic design of the mold filling process; however, due to the high number of influencing variables, the real behavior cannot be exactly reproduced. The focus of this work is on flow front monitoring in an HP-RTM mold using phased array ultrasonic testing. By using an established non-destructive testing instrument, the effort required for integration into the manufacturing process can be significantly reduced. For this purpose, investigations were carried out during the production of test specimens composed of glass fiber-reinforced polyurethane resin. Specifically, a phased array ultrasonic probe was used to record individual line scans over the form filling time. Taking into account the specifications of the probe used in these experiments, an area of 48.45 mm was inspected with a spatial resolution of 0.85 mm derived from the pitch. Due to the aperture that had to be applied to improve the signal-to-noise ratio, an averaging of the measured values similar to a moving average over a window of 6.8 mm had to be considered. By varying the orientation of the phased array probe and therefore the orientation of the line scans, it is possible to determine the local flow velocities of the matrix system during mold filling. Furthermore, process simulation studies with locally varying fiber volume contents were carried out. Despite the locally limited measuring range of the monitoring method presented, conclusions about the global flow behavior in a large mold can be drawn by comparing the experimentally determined results with the process simulation studies. The agreement between the measurement and simulation was thus improved by around 70%.

Simulation of Warpage and Mold Flow in the LFT-D Process

Numerical simulation of filling flow of polymer melt in injection molding

Simulation of Reinforced Reactive Injection Molding with the Finite Volume Method

Towards 3D Process Simulation for In Situ Hybridization of Fiber-Metal-Laminates (FML)

Optimization of Compression Molding Process Parameters for NFPC Manufacturing Using Taguchi Design of Experiment and Moldflow Analysis

INTEGRATED SIMULATION OF MELT FLOW, FIBER FRACTURE AND FIBER ORIENTATION FOR FIBER REINFORCED PLASTICS IN INJECTION MOLDING

A 2D modeling approach for fluid propagation during FE-forming simulation of continuously reinforced composites in wet compression moulding

Injection molding simulation of short fiber reinforced thermosets with anisotropic and non-Newtonian flow behavior

Simulation method for filling stage in liquid composite molding based on a two-phase flow volume of fluid model

Experimental and numerical investigations on thermoforming of thermoplastic prepregs of glass fiber reinforced nylon 6

Flow Front Monitoring in High-Pressure Resin Transfer Molding Using Phased Array Ultrasonic Testing to Optimize Mold Filling Simulations

Research on Lightweight Injection Molding (CAE) and Numerical Simulation Calculate of New Energy Vehicle

A Numerical Simulation Method for the One-Step Compression-Stamping Process of Continuous Fiber Reinforced Thermoplastic Composites

Forming Simulation of Thick AFP Laminates and Comparison with Live CT Imaging

Non-isothermal simulation on injection/mold temperatures in liquid composite molding process

Simulation and Process Analysis of DLP 3D Printing with High-strength Resin

SIMULATION OF MULTI-STAGE COLD FORMING OF A THIN-WALLED VESSEL

Multiscale numerical modeling of large-format additive manufacturing processes using carbon fiber reinforced polymer for digital twin applications

Using long fiber thermoplastic composites as substitutes for metal: design considerations

Integrated computational modeling of large format additive manufacturing: Developing a digital twin for material extrusion with carbon fiber-reinforced acrylonitrile butadiene styrene

Validation of a Simulation Methodology for Thermoplastic and Thermosetting Composite Materials Considering the Effect of Forming Process on the Structural Performance