Abstract:Phase-transformations and microstructural evolution during and after inter-critical annealing of a low-alloy, dual-phase steel are studied utilizing dilatometric measurements, and microstructural characterization methods, including scanning electron microscopy, synchrotron X-ray diffraction, and atom-probe tomography. Dilatometric measurements reveal that the sample contains ~72% austenite, after annealing for 5-min at 871 oC, which agrees with the water-quenched microstructure, and ~90% after further annealing to 1 h, which agrees with thermodynamic predictions. A continuous-cooling transformation (CCT) diagram is constructed, within the cooling-rate range between 1 oC/s and 70 oC/s. The incubation time for the ferrite-transformation is <1 s, after inter-critical annealing, and the secondary-phases are mainly pearlite for cooling-rates of <5 oC/s, and martensite for cooling-rates >10 oC/s, which is confirmed utilizing scanning electron-microscope observations. The microhardness increases as the cooling rate increases, and an abrupt slope-change is explained by the major secondary-phase changing from martensite to pearlite between 5 oC/s and 10 oC/s. Atom-probe tomography demonstrates the coexistence of martensite and pearlite as secondary-phases for 30 oC/s and a switch in austenite-ferrite transformation mechanisms from para-equilibrium (70 oC/s) to partitioning local-equilibrium (30 oC/s). A microstructural map is constructed to reveal the austenite decomposition products in the cooling-rate range between 1 oC/s and 70 oC/s. Based on composition measurements of the matrix, utilizing APT, the effects of cooling-rates on solid-solution-strengthening are estimated, and the results demonstrate that solid-solution strengthening, especially carbon-redistribution, accounts for the majority of the strength variations due to different cooling-rates. (239 words)

A Special Phase Transformation Phenomenon in High Degree of Supersaturation Nitrogenous Supercooled Austenite

A Special Phase Transformation Phenomenon in High-Nitrogen Austenite

Structural Evolution of Topologically Closed Packed Phase in a Ni-based Single Crystal Superalloy

In-situ Observation of Phase Transformation During Heat Treatment Process of High-Carbon Bainitic Bearing Steel

Isothermal transformation of high-nitrogen austenite

Intermediate Temperature Transformation of the High-nitrogen Austenite

Mediate Temperature Transformation on Grain Boundaries of High-Nitrogen Austenite

Research on Mediate Temperature Decomposition of High Nitrogen Austenite

Decomposition of Supercooled Austenite in Continuous Cooling Transformation Process of a Mn-Mo-Ni Low Alloy Steel

Research on the Phase Transformation of a Newly Developed Carbonitride-Strengthened Martensitic Heat Resistant Steel

Microstructure and Characterization of High Hardness Produced in High-Nitrogen Austenite Intermediate Temperature Transformation

Isothermal Transformation of Low Temperature Super Bainite

Insitu Study Of Phase-Transformations In A 50.8 At-Percent Ni-Ti Alloy

Inversion of Nitrogen Redistribution in Austenitic Steel by Severe Plastic Deformation

New Insights on Nucleation and Transformation Process in Temperature-Induced Martensitic Transformation

Atom-probe tomographic and dilatometric studies of phase-transformations after inter-critical annealing of a low-carbon dual-phase steel

Investigation of microstructural evolution and bainite transformation kinetics of multi-phase steel

Morphology and Crystallographic Orientation Relationship in Isothermally Transformed Fe–N Austenite

Evolution of ultrafine bainite microstructure during rapid heating process and the role of retained austenite

Effect of non-isothermal deformation of austenite on ferrite transformation behavior studied by in-situ neutron diffraction

Cyclic Stress Induced Phase Transformation in Super-Bainitic Microstructure