Effect of phase transformation sequence on the low cycle fatigue properties of bainitic/martensitic multiphase steels
Yu Zhang,Xiaoyan Long,Zhen Zhang,Ranran Zhu,Yanguo Li,Fucheng Zhang,Zhinan Yang,Zhang Yu,Long Xiaoyan,Zhang Zhen,Zhu Ranran,Li Yanguo,Zhang Fucheng,Yang Zhinan
DOI: https://doi.org/10.1016/j.ijfatigue.2023.107995
IF: 5.489
2023-10-10
International Journal of Fatigue
Abstract:The three microstructures of bainite-fresh martensite, pre-martensite-bainite and carbide-free bainite were obtained by modulating the phase transformation sequence by the heat treatment process in the medium-carbon multiphase steel. The effects of martensitic and bainitic phase transformation sequences on the low cycle deformation behavior of multiphase steels were investigated. The results showed that the sample of the fresh martensite transformation process (295 °C-15 min) exhibited the best fatigue life among all processes under strain control. The samples of the preformed martensite transformation process (250 °C-295 °C) and the carbide-free bainite transformation process (295 °C-120min) exhibited similar fatigue life. The sample of 295 °C-15 min possesses good resistance to plastic destabilization, resulting in higher fatigue life. The results of the EBSD crack propagation path analysis demonstrate that high carbon M/A islands block crack propagation in the sample of 295 °C-15 min, and high angular grain boundaries skew the crack propagation path. Fracture scans observed that secondary cracks in the sample of 250 °C-295 °C extend inward with aggregation of voids, which are more likely to form crack sources.
materials science, multidisciplinary,engineering, mechanical