Abstract:In the traditional water-jet guided laser (WJGL) processing system, convex lens is used to focus Gaussian laser beam, where the waist and divergence angle are constrained. The focal depth is small, and there are problems such as divergence angle and aberration, which results in the difficult coupling adjustment because the adjustment range of laser coupling to water-jet fiber is limited to the Rayleigh range. In this study, non-diffraction laser (NDL) is generated by an axicon, which has the characteristics of small central spot and large non-diffraction range (NDR). The axial random coupling is realized in the NDR, and the problem of axial coupling between the focused laser and the water-jet generated by nozzle micro-hole is solved. Besides, this paper presents a novel technique to generate NDL by the combination of concave axicon (CCA) and convex axicon (CVA), which solves the small cone angle of the single CVA and the non-modulation defect of the corresponding optical and mechanical structure, and extends the starting point of the NDR to improve the coupling utilization rate of the NDR and the flexibility of the system. The focusing and coupling transmission characteristics of convex lens and axicons mode in WJGL are compared and analyzed. The generated NDL in the NDR at the axial reference coordinate point position of 50 mm and 70 mm is successfully coupled into the water-jet fiber. After the coupling transmission of 20 mm, the coupling efficiency, the morphology of the transmitted spot and the peak power density were basically the same, and the coupling efficiency of the central spot was about 81 %. However, the output spot peak power density and coupling efficiency decrease sharply when the axial coupling deviation exceeds 5 mm adopting convex lens. In contrast, the NDL can achieve a random coupling with high axial coupling tolerance in NDR. The research provides a solution for efficient adjustment and transmission of laser coupling into water-jet in highly stable WJGL.

Wide-beam collimating method with double LD modulation

Laser Collimation Method Based on Differential Compensating Beam Drift

A Novel Method To Enhance The Sensitivity For Two-Degrees-Of-Freedom Straightness Measurement

High-Accuracy Method for Measuring Two-Dimensional Angles of A Linear Guideway

Measuring Straightness Method with Common Path Compensation for Laser Drift

A Novel Method to Simultaneously Measure the Straightness

Method for Active Spatial Alignment and Stabilization of Laser Beams in Multi-Beam Systems

Auto-focusing in ldws by using collimating eyelet method

A PD-edge method associated with the laser autocollimation for measurement of a focused laser beam diameter

Mode-locked Laser Autocollimator with an Expanded Measurement Range.

High-precision Small-angle Measurement of Laser-fiber Autocollimation Using Common-path Polarized-light Difference

A Novel Method for Measuring, Collimating and Maintaining the Spatial Pose of Terminal Beam in Laser Processing System Based on 3D and 2D Hybrid Vision

Beam Drift Reduction by Straightness Measurement Based on a Digital Optical Phase Conjugation

Deformable mirror resolution-matching-based two-stage wavefront sensorless adaptive optics method

Beam-shaping of Laser Diode Stack for Uniform Illumination by Cylindrical Micro-Lenses

Common-path design criteria for laser datum based measurement of small angle deviations and laser autocollimation method in compliance with the criteria with high accuracy and stability.

High coupling efficiency with large axial direction coupling adjustment range in water-jet guided laser

Suppression of Effects of Air Random Disturbances in Laser Collimation Measurements

Small-angle measurement in laser autocollimation based on a common-path compensation method

Design of an Array Collimating System Based on VCSEL Light Source

Adaptive straightness measurement system with dual-frequency laser