Abstract:The recrystallized grain size and texture in alloys can be controlled via the microchemistry state during thermomechanical processing. The influence of concurrent precipitation on recovery and recrystallization is here analyzed by directly correlating (sub)grains of P, CubeND or Cube orientation with second-phase particles in a cold-rolled and non-isothermally annealed Al-Mn alloy. The recrystallized state is dominated by coarse elongated grains with a strong P, weaker CubeND and even weaker Cube texture. The correlated data enables orientation dependent quantification of the density and size of dispersoids on sub-boundaries and subgrains in the deformation zones around large constituent particles. A new modified expression for the Smith-Zener drag from dispersoids on sub-boundaries is derived and used. The results show that the drag on (sub)grain boundaries from dispersoids is orientation dependent, with Cube subgrains experiencing the highest drag after recovery and partial recrystallization. The often observed size advantage of Cube subgrains in Al alloys is not realized due to the increased drag, thereby promoting particle-stimulated nucleation (PSN). Relatively fewer and larger dispersoids in deformation zones around large particles give a reduced Smith-Zener drag on PSN nuclei, thus further strengthening the effect of PSN. Observations substantiating the stronger P texture compared to the CubeND texture are a higher frequency of P subgrains and a faster growth of these subgrains. The applied methodology enables a better understanding of the mechanisms behind the orientation dependent nucleation and growth behavior during recovery and recrystallization with strong concurrent precipitation in Al-Mn alloys. In particular, the methodology gives new insights into the strong P and CubeND textures compared to the Cube texture.

PARTICLE STIMULATED NUCLEATION AND THE FORMATION OF RECRYSTALLIZATION TEXTURE IN Al-Mn ALLOY CONTAINING PARTICLES I. Deformation Zones Around Particles and Particle Stimulated Nucleation

On the formation of recrystallization textures in binary Al-1.3% Mn investigated by means of local texture analysis

Formation of recrystallization texture with rolling orientation in Al-1.3%Mn alloy

Three-dimensional investigation of recrystallization nucleation in a particle-containing Al alloy

Special orientation relationships observed at the early stages of recrystallization in pure AlMn alloy

Particle-stimulated nucleation and recrystallization texture initiated by coarsened Al2CuLi phase in Al–Cu–Li alloy

In-situ observations of static recrystallization and texture formation in a cold-rolled CoCrFeMnNi high entropy alloy

THE FORMATION OF CUBE TEXTURE DURING RECRYSTALLZATION COLD ROLLED Al-Mn ALLOY

Evolution of Micro-Textures Within Individual Grains in Rolled Polycrystal Aluminum

Quasi in Situ Investigation on the Influence of Particle Stimulate Nucleation on Recrystallization Textures in TiB 2 Particles Reinforced Al-3wt%Mg Composites

Nucleation of Recrystallization in Magnesium Alloy Grains of Varied Orientation and the Impacts on Texture Evolution

On the role of selective nucleation and growth to recrystallization texture development in a Mg-Gd-Zn alloy

In-situ Observations of Nucleation in Al-0.1Mg

Systematical Analysis on the Grain Orientation Evolution of Pure Nickel under Plastic Deformation by Using In-Situ EBSD

Texture Selection Mechanisms During Recrystallization and Grain Growth of a Magnesium-Erbium-Zinc Alloy

Microstructure and Texture Evolution During Recrystallization of A Fe-Mn-C Alloy

Orientation dependent pinning of (sub)grains by dispersoids during recovery and recrystallization in an Al-Mn alloy

Cold Rolling Texture Evolution of TiB2 Particle Reinforced Al-based Composites by Neutron Diffraction and EBSD Analysis

Texture and Deformation Structure Evolution During Rolling of Individual Grains of Columnar Grain Nickel

Registration of Data from a Multimodal Investigation of Particle Stimulated Nucleation in Aluminum

Formation of Cube Texture Affected by Neighboring Grains in a Transverse-Directionally Aligned Columnar-Grained Electrical Steel