Abstract:Dynamic analysis is of great importance not only for understanding the natural characteristics and dynamic response of a rotor-bearing system, but also for supplying knowledge of the fault mechanism. The dynamic analysis of a large-scale water-turbine generator set has rarely been investigated. This article establishes a model of a large water-turbine generator set and presents some research results. This article provides a detailed calculation of the critical speed and vibration modes by the Riccati transfer matrix method (RTMM) to study the influence of stiffness of the guide bearings on the characteristics of the shaft. A detailed dynamic model is presented of the No. I unit of the Guangzhou Pumped Storage Power Station (GPSPS) in southern China, including nonlinear characteristics of the guide bearing, the thrust bearing, and the magnetic force. An efficient simulation method, referred to as the transient Riccati transfer matrix method (TRTMM), is used to calculate the transient response of the rotor-bearing shaft system. Sonic simulation results are also presented for responses to other types of forces such as unbalance inertial forces and nonlinear magnetic forces. Results show that, for large vertical water-turbine generator sets, there exists a common characteristic in the first three vibration modes, that is, the maximum amplitude is at the generator rotor in the first vibration mode, while in the third vibration mode, the maximum amplitude is near the turbine runner. Simulation results show that the method and program are correct and can be used expediently. The response of the rotor-bearing system with different values of preload coefficients of the tilting-pad journal bearing reflects the influence of the bearing clearance on the vibration amplitude and the time required for the vibration from transient state to steady state. The effect of hydraulic forces acting on the runner shows that the vibration amplitude and the time required for the vibration at the three guide bearings to reach steady state are different. The analysis of the lateral shaft vibration caused by nonlinear magnetic forces shows that it will produce a new frequency component of 150 Hz.

Study on dynamic thermal stresses in large-scale steam turbine rotors

Calculation of Finite Element of Thermal Stress and Analysis of Low-cyclic Fatigue Life for Non-central Hole Rotor of 135 MW Turbine

New Monitoring Model of Thermal Stresses on Steam Turbine Rotors

Viscoplastic Model-Based Analysis of In-Service Oscillation Temperature and Thermal Stress in a Rotating Component

Dynamic characteristics of the rotor system for large pump-turbine sets

Calculation and Analysis of Thermal Stress for High Pressure Rotor of Steam Turbine

Study On Structural Optimization Of Large Power Steam Turbine High Pressure Rotor Based On Thermal-Structural Coupling Analysis

Dynamic Stress Analysis of Francis Turbine with Partial Load

Numerical Analysis of the Dynamic Characteristics of Combined Labyrinth-Rotor Systems of Steam Turbines

Evolution of Principal Stress of a Turbine Rotor under Cyclic Thermo-Mechanical Loading

Transient thermal impact research on turbine rotors based on thermoelastic coupling

Dynamic Analysis of Turbocharger Rotor Bearing with an Integrated Three Dimensional Thermohydrodynamic Model

The Steady-State Thermal Effect On Rotordynamics Of A Rod-Fastened Rotor-Bearing System

Dynamic model research for nuclear steam turbine

Analysis of Dynamic Stresses of Pump-Turbine Runner During Load Rejection Process in Turbine Mode

The Turbine Rotor Thermal-stress Online Monitor and Fatigue Life Analysis

The Steady-State Thermo-Mechanical Analysis of Turbine Rotor

DYNAMIC ANALYSIS OF A HYDRAULIC TURBINE UNIT*

INTERVAL ARITHMETIC BASED GRAY MODEL ON THERMAL STRESSES FIELD ONLINED COMPUTATION OF TURBINE ROTOR

Study on 3-Dimensional Dynamic Stress and Service Life of Large Steam Turbines' Last Stage Blades

Study on Numerical Model for Welding Process of Steam Turbine Rotor Based on Three-Dimensional Finite Element Method