Abstract:Abstract The measurement of gas flow rates is of great importance in a wide range of modern technologies. This paper introduces a simple, yet accurate technique for in-house calibration of gas FMs (mass and volumetric) even under harsh environmental conditions such as encountered during field measurement campaigns. The method requires only readily available, low cost components: a vessel of known volume, an air pump, a pressure sensor and a metal plate orifice or a needle valve to act as a CO. The unique property of choked flow in the CO is used here for flow calibration. In the method presented here a vessel is evacuated to below the critical pressure (<0.53 of upstream pressure) and then allowed to refill with ambient air (or some other process gas) under so-called choked flow conditions through the CO. The method presented here leverages that the flow rate upstream of the CO is not only constant but readily determined from (a) the known V VESS , (b) the measured time rate of change of the absolute pressure in the vessel and (c) the ideal gas law. This calculated flow rate can be used for calibration of FMs. The accuracy of the method depends only on the accuracy of the pressure measurement, the timer and the value of the V VESS . The flow rate computed in this way is found to be in excellent agreement (typically 1% difference) with the flow rate measured by a soap film FM (Gilibrator). As expected from theory this method is found to work for all kinds of CFRs (here: various types of metal plate orifices and needle valves were tested), gas types (here: air, Argon, and CO 2 ) and upstream pressures (here: between 650 hPa and 1400 hPa). The accuracy of this technique (∼1%) is as good as that of standard volume displacement methods (e.g. soap film FMs) (typically 1% difference), the standard of laboratory-based flow calibrators, but less expensive and more suitable for harsh environments.

Flow-injection calibration procedures with the use of fully rotary valve

Research on Dynamic Characteristics of the Rotary Valve.

A New Flow Injection Calibration System Based On Automatic Diagnosis And Correction For Fault Peak Signal Using Flow Injection Gradient Information

Flow Stabilizer on a Syringe Tip for Hand-Powered Microfluidic Sample Injection

On-chip integrated multi-thermo-actuated microvalves of poly(N-isopropylacrylamide) for microflow injection analysis

A New Flow Injection Single-Standard Calibration Method for Flame Atomic Absorption Spectrometry Based on Dilution by Microsample Dispersion

Flow Control of a Proportional Directional Valve Without the Flow Meter

Flow Rate Adjustable Ratio Analysis of a Novel Control Valve with Double Sleeve

A Flow Inferential Measurement of the Independent Metering Multi-Way Valve Based on an Improved RBF Neural Network

Flow Force Analysis and Structural Optimization of a Large Flow Rate Pressure Compensation Valve

An indirect flow measurement based high-precision slide valve grinding mechanism for hydraulic servo valve

Flow Characterization of a PiezoElectric High Speed Valve

The Third Generation of Flow Injection Analysis:Current Situation and Perspectives of Lab-on-Valve Scheme

INJECTION VELOCITY CONTROL BASED-ON AN ITERATIVE LEARNING AND FEEDBACK COMBINED CONTROLLER

FLow-injection analysis: a new approach to quantitative measurements in clinical chemistry.

Calibration and Optimization of an Insertion Electromagnetic Flowmeter With the Aid of Numerical Analysis

Microfluidic Chip-Based Valveless Flow Injection Analysis System with Gravity-Driven Flows.

METHODOLOGY FOR CALCULATING THE FLOW-RATE CHARACTERISTICS OF A CHEMICAL INJECTION METERING (THROTTLE) VALVE WITH A LAMINAR AND TURBULENT STAGE OF A SHUT-OFF AND CONTROL ELEMENT

Fast model-based calibration of multiple injections for a CI engine using nonlinear optimal control

Calibration of gas flow meters using choked flow and an evacuated vessel

Flow injection analysis (FIA) — a personal view