Abstract:The acidic (pKa ≈1.5–2.5) and hygroscopic nature of poly(3,4-ethylene dioxythiophene) polystyrene sulfonate, used as a common hole-injection layer in optoelectronic devices, has a detrimental effect on device stability and is associated with well established device failure mechanisms. In this work, a process with a high green index hole-injection layer material (V2O5) and low surface roughness (RMS roughness ≈1.3 nm) was developed for demonstrating a hybrid polymer–inorganic perovskite light-emitting diode. Test devices with the new hole-injection layer demonstrate nearly identical maximum current efficiencies (4.23 vs 4.19 cd/A), and luminous efficacies (2.99 vs 2.32 lm/W) when compared to a control device fabricated with the conventional hole-injection layer. Furthermore, the peak brightness was achieved at a current density one-third of the value for the control device. To examine the transport of holes in the above hole-injection layer, we carried out device simulations based on a physical charge control model, including defect-assisted tunneling for hole injection. Close agreement for current–voltage characteristics is observed. Experimentally measured mobility in the device and measured radiative lifetimes were found to be sufficient to achieve this agreement without resorting to the introduction of a sheet charge at the injection interface. Despite the use of a bulk-heterojunction device architecture, the model predicts high radiative recombination rates [≈5.6×1022/(cm3s)] in the emissive layer, consistent with the measured photophysical properties for the active film, suggesting effective passivation of non-radiative surface states.

Studies On Carrier Confinement For Polymer Electroluminescent Devices With Multilayer Structure

Analysis on Mechanism of Current Transport in Organic Electroluminescent Thin Film Device

Experimental Study of Low-Voltage -Driven Thin Film Electroluminescence Mechanism

Study on the mechanism of organic thin film electroluminescence

Carriers Confinement for Polymer Electroluminescent Devices with Multilayer Structure

Carrier transport and high-efficiency electroluminescence properties of copolymer thin films

Investigating the Effect of the Conductivity of the Electron Transportation Layer on the Organic Light-Emitting Diodes

Redistribution of Carriers in Oel Devices by Inserting A Thin Charge-Carrier Blocking Layer

Study on High-Brightness Green Organic Light-Emitting Devices Using PS-TPD as Hole Transporting Layer

Design of Hole Blocking Layer with Electron Transport Channels for High Performance Polymer Light‐Emitting Diodes

Defect-assisted hole transport through transition metal oxide-based injection layers for passivated nanocrystalline CsPbBr3 emissive thin films: A combined experimental and modeling study

The effect of carrier transport layer on the electroluminescent properties of solution‐processed thermally activated delayed fluorescent device based on 4CzPN

Organic Electroluminescent Device Based on Balanced Carriers Injection and Transportation

Blue polymer light-emitting diodes with organic/inorganic hybrid composite as hole transporting layer

Study of Electroluminescence and Electron Injection on Novel Red Polyelectrolytes Copolymer

Single-crystalline hole-transporting layers for efficient and stable organic light-emitting devices

Improvement in performance of organic light-emitting diodes by adjusting charge-carrier mobility in organic/inorganic hybrid hole transporting layer

Performance optimization of polymer doped electrophosphorescent organic light-emitting diodes

Control Of Carrier Transport In Organic Semiconductors By Aluminum Doping

Effect of CsF Buffer Layer on Charge-Carrier Mobility in Organic Light-Emitting Diodes Based on a Polyfluorene Copolymers by Admittance Spectroscopy

Film-forming Hole Transporting Materials for High Brightness Flexible Organic Light-Emitting Diodes