Abstract:Polycarbonate is a widely used ductile glassy polymer that can undergo large strain deformation before failure. During the plastic deformation process, some mechanical energy is converted to heat, which, if the specimen is loaded at rates sufficient that the heat cannot conduct out of the material, can result in significant temperature rises that affect the mechanical response. Typically, this is expected to result in a reduction in stress at large strain, compared to the behaviour under isothermal conditions; however, compared to other glassy polymers, it has been observed that less softening than expected is experienced in polycarbonate at high strain rates. The current paper describes a thorough investigation of temperature rises in polycarbonate. Compression experiments are performed using a screw-driven machine, a hydraulic machine, and a long split Hopkinson bar, all instrumented with a high-speed infrared camera to measure temperature rises at strain rates between 0.01 and 2600 s -1 at a starting temperature around 20°C. Further, temperature rises in compression experiments at 0.5 s -1 and starting temperatures between -80 to 150°C are measured using embedded thermocouples. These span the range of the secondary- to glass-transitions of polycarbonate, allowing investigation of the effect of these transitions. These experiments are supported by finite element simulations, which use a phenomenological viscoplastic model, to ensure the thermal boundary conditions are adiabatic. Temperature rises are observed in both temperature and rate-dependent tests: experiments at higher strain rates and lower temperatures experience a greater temperature rise because of the higher yield stress; however, there are differences in the conversion ratio between plastic work and heat (Taylor Quinney coefficient), which is both temperature and rate dependent, and strongly affected by both the secondary and glass transitions.

Influence of technological parameters on mechanical property of injection-compression polycarbonate plate

Influence of Hot Press Molding Parameters on the Tensile Strength of Bamboo Fiber/PLA Composites

Influence of Processing Parameters on the Mechanical Properties of Peek Plates by Hot Compression Molding

Experimental study on mechanical behaviors of injection molded PC/PMMA blends

Experimental and Modeling Study of the Compressive Behavior of PC/ABS at Low, Moderate and High Strain Rates

The Influence of Mold Pressing Parameters on Ptc of Hdpe/Cb Composites

Process parameter–mechanical property relationships and influence mechanism of advanced CFF/PEEK thermoplastic composites

Study on Processing Parameters of Ceramic Injection Moulding

Effects of Injection Molding Parameters on Properties of Insert-Injection Molded Polypropylene Single-Polymer Composites

Influences of Process Parameters on Mechanical Properties of ABS/Aluminum Powder Blending Products

Effects of processing on mechanical properties of polypropylene composites

Influence On The Mechanical Behavior Of Carbon Fiber Fabric Reinforced Pps Laminates Under Different Temperature

The impact of injection molding process parameters on mechanical properties and microstructure of PC/ABS blends using Taguchi approach

A multi-scale analysis to predict elastic response in different weight fractions of carbon fiber powder

Investigation of Tensile Deformation Behavior of PC, ABS, and PC/ABS Blends from Low to High Strain Rates

Study on the influence of in-mold sequential injection molding process parameters on mechanical properties of self-reinforced single composites

Experimental study on impact tensile properties of polycarbonate at low temperature

Thermomechanical coupling during large strain deformation of polycarbonate: Experimental study

Effect of processing parameter changes on mechanical properties during injection molding: Amorphous versus semi‐crystalline materials

High Strain-Rate Tensile Experiment on Polycarbonate Bar

Study of Dynamic Failure Behavior of a Type of PC/ABS Composite