Abstract:The design of an interfacial structure is particularly important for load transfer in composites. In this paper, different amounts of carbon nanotubes (CNTs) were grafted onto the carbon fiber (CF) surface by adjusting grown temperature using injection chemical vapor deposition (ICVD). The prepared CF preform grafted with CNTs (CNTs-CF) were used to reinforce magnesium alloy by squeeze casting process. The microstructures were analyzed by means of optical microscope (OM) and scanning electron microscope (SEM), and the interlaminar shear strength (ILSS) and tensile strength of the composites were determined by double-notch shear test and tensile test. The results indicated that moderate ILSS was more conducive to improving the tensile properties of carbon fiber reinforced magnesium matrix (Cf/Mg) composites. Compared with Cf/Mg, the tensile strength of composite with CNTs increased by about 80%. For Cf/Mg composites grafted with CNTs, CNTs had the effects of delaying crack propagation and increasing energy consumption by the pull-out and bridging mechanism, which were the main reasons for improving the strength. The analysis of shear fracture surface showed that the crack propagation path can be optimized by adjusting the amounts of grafted CNTs. The presence of CNTs affects the stress distribution and consequently the crack initiation as well as the crack propagation.

Prickly structure of multi-walled carbon nanotube reinforced mesocarbon microbead composite with high strength at elevated temperature

Fabrication and mechanical properties of in situ prepared mesocarbon microbead/carbon nanotube composites

Carbon-nanotube-templated Carbon Nanofibers with Improved Mechanical Performance

Properties of Carbon Nano-Tubes–cf/sic Composite by Precursor Infiltration and Pyrolysis Process

Interface enhancement of carbon nanotube/mesocarbon microbead isotropic composites

A New Structure for Multi-Walled Carbon Nanotubes Reinforced Alumina Nanocomposite with High Strength and Toughness

Densification of in Situ Prepared Mesocarbon Microbead/carbon Nanotube Composites by Hot-Press Sintering

Simultaneous improvement of microstructure and high-temperature tensile properties in CNT-doped Mo-based composites

Machine Learning-Assisted High-Throughput Molecular Dynamics Simulation of High-Mechanical Performance Carbon Nanotube Structure

The Microstructure and Mechanical Properties of Carbon Nanotube-Reinforced W-Matrix Composites

Enhanced Mechanical Properties of Prestressed Multi-Walled Carbon Nanotubes.

Multi-walled carbon nanotube-based carbon/carbon composites with three-dimensional network structures.

Investigation of Microstructure and Strengthening Mechanism in CNTs Reinforced Mo-based Composites

Effect of carbon nanotubes grown temperature on the fracture behavior of carbon fiber reinforced magnesium matrix composites: Interlaminar shear strength and tensile strength

Preparation and Microstructure of Multi-Wall Carbon Nanotubes-Toughened Al2O3 Composite

Improving thermal shock and ablation resistance of high thermal conductivity carbon/carbon composites by introducing carbon nanotubes

Epitaxial Grown Carbon Nanotubes Reinforced Pyrocarbon Matrix in C/C Composites with Improved Mechanical Properties

TiC-modified CNTs as reinforcing fillers for isotropic graphite produced from mesocarbon microbeads

Compressive Strength and Microstructure of Multi-Wall Carbon Nanotubes Reinforced Cement Composites

Effects of the addition of multi-walled carbon nanotubes on the microstructure and properties of Ti(C,N)-based cermets prepared by spark plasma sintering

Microstructure-toughening Relation in Alumina Based Multiwall Carbon Nanotube Ceramic Composites