Abstract:Densified multiwalled carbon nanotube (MWNT)-BaTiO3 composites were successfully fabricated through a spark plasma sintering (SPS) method. The influences of sintering temperature, annealing time, and the content of carbon nanotubes on the densification of composites were studied in detail. The morphology of fracture surface was observed using field emission scanning electron microscope (FE-SEM). Through analyzing the temperature dependent shrinkage rate, we found that the incorporation of carbon nanotubes can effectively accelerate the densification process of MWNT -BaTiO3 composites. Excellent electrical and thermal conductivity of MWNTs were proposed to account for this unexpected sintering behavior. Thermal properties of MWNT-BaTiO3 composites, including specific heat capacity, thermal diffusivity, and thermal conductivity, were also principally investigated. The experimental results show that the thermal diffusivity and thermal conductivity both unusually decreased although the specific heat capacity increased after adding CNTs into composites. It was suggested that the interfacial thermal barrier between CNTs and the BaTiO3 matrix plays a crucial role in determining the thermal conductivity of bulk composites. A simplified effective medium approximation formulation was used to simulate and predict the thermal conductivity of the MWNT-BaTiO3 composite, but only fitted well with the measured values for low CNTs content (2.45 vol%). The reason for this deviation was proposed and needs further work to make it clear thoroughly.

Densification of in Situ Prepared Mesocarbon Microbead/carbon Nanotube Composites by Hot-Press Sintering

Fabrication and mechanical properties of in situ prepared mesocarbon microbead/carbon nanotube composites

Properties of Carbon Nano-Tubes–cf/sic Composite by Precursor Infiltration and Pyrolysis Process

Prickly structure of multi-walled carbon nanotube reinforced mesocarbon microbead composite with high strength at elevated temperature

In-situ pressing synthesis of densely compacted carbon nanotubes reinforced nanocomposites with outstanding mechanical performance

Processing and Properties of Carbon Nanotubes-Nano-wc-co Composites

Improving the performance of carbon composites by liquid phase activated sintering of MCMBs doped with Ti/Ni or Fe/Ni

Processing of Multi-Walled Carbon Nanotube-Reinforced Tini Composites by Hot Pressed Sintering

Sintering And Enhanced Mechanical Properties Of Densified Multiwalled Carbon Nanotube/Tin Composites

Interface enhancement of carbon nanotube/mesocarbon microbead isotropic composites

Improved Mechanical Properties of Csf/SiC Composite by Rapid Hot Press Sintering

Effect of Nano-Sic on the Sintering Behavior and Properties of Calcined Carbon Derived from Mesocarbon Microbeads

Fabrication Of Barium Aluminosilicate-Silicon Nitride-Carbon Nanotube Composites By Pressureless Sintering

Sintering And Thermal Properties Of Multiwalled Carbon Nanotube-Batio3 Composites

Slurry‐impregnating hot‐press sintered silicon carbide nanofiber/silicon carbide composites with Al‐B‐C as sintering additives

TiC-modified CNTs as reinforcing fillers for isotropic graphite produced from mesocarbon microbeads

Rapid in-situ reaction synthesis of novel TiC and carbon nanotubes reinforced titanium matrix composites

Multi-wall Carbon Nanotubes Reinforced Aluminum Composites Synthesized by Hot Press Sintering and Squeeze Casting

Carbon/Carbon Composites Prepared from Mesocarbon Microbeads Reinforced by Carbon Fiber

Densification behavior, mechanical and electrical properties of in-situ TiB 2p /Cu composite powder via vacuum hot pressing

Microstructures of a carbon-fiber-reinforced silicon-carbide composite produced by precursor pyrolysis and hot pressing