Abstract:To avoid the energy waste in the production of furnace grade phosphoric acid, a novel phosphoric reactor with circular water wall is designed, which could recover waste heat to produce superheated steam with the help of drum. A three-dimensional mathematical model of phosphorus combustion in the novel phosphoric reactor is developed by incorporating kappa-epsilon turbulence model, eddy dissipation combustion model and P-1 radiation heat transfer model. The streamline field distribution, temperature distribution and species concentration distribution are predicted by numerical simulation. The results show that phosphorus combustion mainly takes place in the injection zone of atomised phosphorus; the maximum combustion temperature and exit temperature are 1790 and 970 K respectively which conform well to practical datum. Meanwhile, the effects of parameters on maximum combustion temperature, smog exit temperature, maximum wall heat flux and averaged wall heat flux of the novel phosphoric reactor with circular water wall are also discussed, including phosphorus consumption, excess air coefficient, wall temperature and radiation absorption coefficient. The predicted results show that maximum combustion temperature, smog exit temperature, maximum wall heat flux and averaged wall heat flux will increase with increasing phosphorus mass flowrate when excess air coefficient is constant. Under the condition of constant phosphorus mass flowrate, the smog exit temperature will increase with increasing excess air coefficient and other parameters will decrease. Wall temperature has a remarkable effect on the smog exit temperature, whereas its effects on other parameters are not obvious. In addition, radiation absorption coefficient has remarkable effects on maximum combustion temperature and maximum wall heat flux in the novel phosphoric reactor.

Numerical Solution for Radiative Heat Transfer in a Novel Polysilicon CVD Reactor

Analysis of radiative energy loss in a polysilicon CVD reactor using Monte Carlo ray tracing method

Numerical Analysis of Industrial Styrene Polymerization in Nonideal Tower Reactors

Development of a polysilicon chemical vapor deposition reactor using the computational fluid dynamics method

Simulation of Heat Transfer in a Vertical Tubular CVD Reactor

Numerical Simulation of Multiple Polysilicon Cvd Reactors Connected in Series Using Cfd Method

Heat and mass transfer characteristics of three-dimensional bell-shaped polysilicon chemical vapor deposition reactor

Development and Cfd Simulation of A Novel Phosphoric Reactor with Waste Heat Recovery

Numerical and experimental study of polysilicon deposition on silicon tubes

CFD-Aided Design for Polysilicon Production System

Mathematical model and energy efficiency analysis of Siemens reactor with a quartz ceramic lining

International Conference on Applied Energy – ICAE 2016 Improvement of Heat and Mass Transfer Performance in a Polysilicon Chemical Vapor Deposition Reactor with Field Synergy Principle L

Numerical Simulation of Radiative Heat Transfer in 24 Pairs of Rod Polysilicon Reduction Furnace

A Revisit from CVD Kinetics to CVD Reactor: Investigating Uniform Growth Mechanism of Polysilicon in a Reduction Furnace

Local Heat and Mass Transfer Characteristics of Different Channel Configurations in Polysilicon Chemical Vapor Deposition Reactor

Optimization of Operating Parameters in Polysilicon Chemical Vapor Deposition Reactor with Response Surface Methodology

Numerical simulation of flow and heat transfer in a novel polysilicon reduction furnace

Optimization of the Thermal Field of 8-Inch SiC Crystal Growth by PVT Method with “3 Separation Heater Method”

Investigation of heat transfer mechanism affecting temperature homogeneity at polysilicon rods in a Siemens reduction furnace

A transport-kinetic model development for polysilicon chemical vapor deposition in a SiHCl3–H2 system

Simulation of temperature profile and design of heat transfer structure for reactor of film growth on Si-wafer