Abstract:The heat transfer performance of fluid flowing in a microchannel was experimentally studied, to meet the requirement of extremely high heat flux removal of microelectronic devices. There were 10 parallel microchannels with rectangular cross-section in the stainless steel plate, which was covered by a glass plate to observe the fluid flowing behavior, and another heating plate made of aluminum alloy was positioned behind the microchannel. Single phase heat transfer and fluid flow downstream the microchannel experiments were conducted with both deionized water and ethanol. Besides experiments, numerical models were also set up to make a comparison with experimental results. It is found that the pressure drop increases rapidly with enlarging Reynolds number (200), especially for ethanol. With comparison, the flow resistance of pure water is smaller than ethanol. Results also show that the friction factor decreases with Reynolds number smaller than the critical value, while increases the velocity, the friction factor would like to keep little changed. We also find that the water friction factors obtained by CFD simulations in parallel microchannels are much larger than experiment results. With heat flux added to the fluid, the heat transfer performance can be enhanced with larger Re number and the temperature rise could be weaken. Compared against ethanol, water performed much better for heat removal. However, with intensive heat flux, both water and ethanol couldn’t meet the requirement and the temperature at outlet would increase remarkably, extremely for ethanol. These findings would be helpful for thermal management design and optimization.

International Conference on Applied Energy – ICAE 2016 Improvement of Heat and Mass Transfer Performance in a Polysilicon Chemical Vapor Deposition Reactor with Field Synergy Principle L

Numerical Investigation on Hydrodynamics and Heat Transfer of Highly Viscous Fluid in Sulzer Mixer Reactor

Progress on agitated apparatus for polymer devolatilization and its CFD simulation

Laminar mixed convection heat transfer of SiC-EG nanofluids in a triangular enclosure with a rotating inner cylinder: simulations based on the measured thermal conductivity and viscosity

Heat and mass transfer characteristics of three-dimensional bell-shaped polysilicon chemical vapor deposition reactor

Simulation of Heat Transfer in a Vertical Tubular CVD Reactor

CFD-Aided Design for Polysilicon Production System

Simulation of temperature profile and design of heat transfer structure for reactor of film growth on Si-wafer

Numerical simulation of flow and heat transfer in a novel polysilicon reduction furnace

Numerical simulation and experimental investigation of multiphase mass transfer process for industrial applications in China

Field Synergy Analysis and Optimization of the Convective Mass Transfer in Photocatalytic Oxidation Reactors

Application of a multi-field synergy principle in the performance evaluation of convective heat transfer enhancement in a tube

Investigation of heat transfer mechanism affecting temperature homogeneity at polysilicon rods in a Siemens reduction furnace

Experimental and Numerical Studies of Fluid Flow Confined in Microchannel

Mass and heat transfer enhancement by a novel mixer with triangular-notched rectangular baffles for continuous flow chemical process

Field Synergy Optimization and Enhanced Heat Transfer by Multi-Longitudinal Vortexes Flow in Tube

Numerical analysis on heat transfer characteristics of a multi-vapor channel vapor chamber with novel ultra-thin composite wick

Multi-model Simulation of 300 Mm Silicon-Nitride Thin-Film Deposition by PECVD and Experimental Verification

Conjugate fluid, heat and species transports inside an enclosure containing miscellaneous solid arrays: General models of electronic cooling and pollutant removals

Application of Field Synergy Principle for Fin Reshaping of a Natural Convection Radiator

Numerical and experimental study of polysilicon deposition on silicon tubes