Abstract:Nanoscale [(Ba0.85Ca0.15)(0.995)Nd-0.005](Ti0.9Hf0.1)O-3 (Nd-BCTH) ceramics were prepared via the hydrothermal method, and the effects of sintering temperature and holding time on the phase structure, micro-morphology, electrical and optical properties of the Nd-BCTH ceramics were explored. All the Nd-BCTH ceramics present rather pure perovskite structure with composition approaching rhombohedral phase around the morphotropic phase boundary (MPB) region. The highest relative density is obtained for the sample sintered at 1220 ? for 10 h. The existence of Ba2+, Ca2+, Ti4+, Hf(4+ )and Nd3+ is confirmed and the elements distribute rather uniformly detected by X-ray photoelectron spectrometer (XPS) and energy dispersive X-ray (EDX) analysis. The ceramics present nanoscale grain size, which tends to increase with the increase of sintering temperature and holding time, and significantly affects dielectric constant and Curie temperature. Very thin and narrow ferroelectric hysteresis loops are observed, where a considerable energy storage density (173.88 mJ/cm(3)) and high energy storage efficiency (80.68%) are obtained at low electric field. The increase of sintering temperature and holding time induces a red shift at 400 nm absorption edge and a blue shift at 300 nm absorption edge in the Nd-BCTH ceramics, and all ceramics have a maximum absorption value at around 260 nm. Under the excitation of 269 nm light, the Nd-BCTH ceramics show the strongest fluorescence peak at 473 nm, corresponding to the (4)G(3/2)-> I-4(9/2) transition, emitting indigo blue fluorescence. When the ambient temperature is above 400 ?, grains conduction dominates the conductive mechanism in the nano-sized Nd-BCTH ceramics. Such conduction can be attributed to oxygen vacancies caused due to the evaporation of alkaline-earth metals during high temperature sintering, and show typically thermally excited relaxation process. (C) 2022 Published by Elsevier B.V.

Low‐Temperature Synthesis of Bi3.15Nd0.85Ti3O12 Nanoplates by a Sol–Gel‐Hydrothermal Method

Low-temperature Synthesis of Bi4Ti3O12 Nanocrystals by Hydrothermal Method

Low-temperature preparation of nanoplated bismuth titanate microspheres by a sol–gel-hydrothermal method

Low temperature synthesis of plate-like Na0.5Bi0.5TiO3 via molten salt method

The synthesis of Bi3.15Nd0.85Ti3O12 nanostructures via hydrothermal method

Low-temperature Synthesis of TiB2 Nanocrystals Using TiO2 ,LiBH4 and Mg

Sol-Gel Preparation of N-doped TiO2 Nanocrystalline at Low Temperature

Low‐Temperature Synthesis of Bismuth Titanate by an Aqueous Sol–Gel Method

Bi4Ti3O12 nanocrystals synthesized via hydrothermal reaction

Preparation of Nanoscale [(ba0.85ca0.15)0.995nd0.005](ti0.9hf0.1)o3 Ceramics Via Hydrothermal Method and Effect of Grain Size on Multifunctional Performance

Low‐temperature Synthesis of Ultrafine TiB2 Nanopowders by Molten‐salt Assisted Borothermal Reduction

Hydrothermal Synthesis and Formation Mechanism of the Single-Crystalline Bi4Ti3O12nanosheets with Dominant (010) Facets

Synthesis of Perovskite Structure (Ca-0.61, Nd-0.26)TiO3 Nanopaticles by Sol-Gel Method

Low-temperature Synthesis of BiFeO3 Nanopowders Via a Sol–gel Method

The Low Temperature Synthesis and Characterization of Bi3.25la0.75ti3o12 Powder by Hydroxide Coprecipitation in Aqueous Medium

Low-Temperature High-Efficiency Preparation of TiB 2 Micro-Platelets via Boro/Carbothermal Reduction in Microwave Heated Molten Salt.

Low-temperature Synthesis and Characterization of Complex Perovskite (ca0.61, Nd0.26)TiO3–(Nd0.55, Li0.35)TiO3 Nanopowders and Ceramics by Sol–gel Method

Low-temperature Preparation of neodymium-doped BiFeO3 Crystallites by a Sol-Gel-Hydrothermal Method

Hydrothermal Synthesized Bi2WO6 Nanoplates: Growth Mechanism and Photocatalytic Activities

Morphology-controlled Synthesis and Growth Mechanism of Lead-Free Bismuth Sodium Titanate Nanostructures Via the Hydrothermal Route

Low Temperature Synthesis of Vanadium Pentoxide Nanocrystallines by Sol-Gel Method