Abstract:Nanocrystalline pure perovskite phase bismuth sodium titanate (Bi0.5Na0.5)TiO3(BNT) powders have been prepared by a sol-gel method from the poly vinyl alcohol evaporation route. bismuth nitrate [Bi(NO3)(3)], tetra-butyl titanate [Ti(OC4H9)(4)] and sodium acetate(CH3COONa) were used as raw materials and poly vinyl alcohol(PVA) as the sol-gel forming solvent. Stoichiometric amounts of the individual raw materials were thoroughly mixed in accordance with the BNT composition to form the stock solution. The pH of the stock was adjusted to 1-3 by adding acetate. Aqueous solution of PVA[10%(w/v)] was then added to the cationic mixture with thorough stirring. The weight ratio of the cationic mixture to the PVA aqueous solution was maintained at 2:1. The resulting viscous liquid was then heated over a hot crucible up to form a fluffy dry gel. The fluffy dry gels were calcined at different temperatures and times and then cooled to room temperature naturally. The X-ray powder diffraction(XRD) patterns of the heat-treated powders were obtained using a Bruker D8 Advance X-ray diffractometer with Cu K alpha radiation and nickel filter. Scanning electron microscope (SEM) studies of the NBT powders were performed using a JSM-6700F electron microscope. Phase-pure BNT powders were obtained at 550 degrees C for 2-2.5h which is relatively lower calcination temperature than other reports. The BNT powders consists of phase-pure perovskite nanocrystals with an average size of 100-200nm.

Synthesis of Perovskite Structure (Ca-0.61, Nd-0.26)TiO3 Nanopaticles by Sol-Gel Method

Low-temperature Synthesis and Characterization of Complex Perovskite (ca0.61, Nd0.26)TiO3–(Nd0.55, Li0.35)TiO3 Nanopowders and Ceramics by Sol–gel Method

Sol–gel Synthesis and Sintering of Nano-Size Li2TiO3 Powder

Preparation and Dielectric Properties of (ca0.61,nd0.26)tio3 Nanoparticles by a Sol–gel Method

Hydrothermal Synthesis of Single-Crystalline Perovskite PbTiO3 Nanosheets with Dominant (001) Facets

Monodisperse Hollow Perovskite BaTiO3 Nanostructures Prepared by a Sol–gel–hydrothermal Method

Glucose Modified Hydrothermal Synthesis of Perovskite Oxide Nanocrystals

Tailoring Synthesis Conditions for [(ba0.85ca0.15)0.995nd0.005](ti0.9hf0.1)o3 Nanopowders by Hydrothermal Method and Their Luminescence Properties

A general process to synthesize self-assembled shell-like (Ca0.61, Nd0.26)TiO3 clusters

Preparation of PbTiO3 Nanocrystal by Sol-Gel Hydrothermal Method

Hydrothermal synthesis of perovskite CaTiO3 tetragonal microrods with vertical V-type holes along the [010] direction

Hydrothermal Synthesis and Photoluminescence of Pre-Perovskite Lead Titanate Nanofibers

Preparation of Ti1-xFexO2 Nanocrystals via Low Temperature Sol-Gel Method

Sol-Gel Preparation of N-doped TiO2 Nanocrystalline at Low Temperature

Sol-Gel Synthesis and Characterization of Nanocrystalline (bi0.5na0.5)tio3 Powders from the Poly Vinyl Alcohol Evaporation Route

Optimization Hydrothermal Synthesis Conditions for Nano-Sized (na0.5 Bi0.495 Nd0.005 )tio3 Particles by an Orthogonal Experiment and Their Luminescence Performance.

Preparation and Properties of CaTiO_3:Zn Nanoparticles Based on Sol-Gel Method

Preparation of Nanocrystalline Anatase Tio2 Using Basic Sol-Gel Method

Hydrothermal Synthesis and Phase-, Morphology-Evolution Mechanism of Lead Titanate Nanostructures Assisted with Tetramethylammonium Hydroxide

Synthesis of Single-Crystalline Pb(Zr0.52Ti0.48)O-3 Nanocrystals by Hydrothermal Method

Sol–gel Synthesis of A-site-ordered and Homogeneous (nd0.55, Li0.35)TiO3 Ceramic and Its Dielectric Properties