Abstract:In this paper, effects of preparing conditions on the nanostructures electrodeposited from the Zn(NO3)2 electrolyte containing KCl were systematically studied. The electrodeposition conditions, such as concentrations of KCl and Zn(NO3)2, electrodeposition potential and temperature, had significant influence on the morphology and composition of electrodeposited nanostructures. A typical nanosheet structure composed of ZnO, Zn5(OH)8Cl2·H2O and Zn was obtained from the electrolyte containing 0.1M Zn(NO3)2 and higher concentration of KCl (≥0.1M). In the electrolyte containing 0.1M KCl, lower concentration of Zn(NO3)2 (≤0.02M) could induce the electrodeposition of ZnO nanospike structures, while the thick and closely packed nanosheets composed of ZnO and Zn5(NO3)2·(OH)8·2H2O were obtained at a higher concentration (0.5M). Varying the potential from 0.1 to 1.0V could not obviously change the morphology and composition of nanosheets from the electrolyte containing 0.1M Zn(NO3)2 and 0.1M KCl, but single and multi-layer nanosheets could be obtained at higher (−0.1V) and lower (≤−0.4V) potentials, respectively. Nanosheets were electrodeposited at the temperature higher than 45°C, and both the thickness and width of nanosheets increased as temperature increased. At a low temperature of 30°C, bundles of elongated and entangled nanowires surrounded by a large amount of tiny nanocrystals were deposited, which were mainly composed of ZnO and Zn. After heat treatment at 450°C for 30min, the as-electrodeposited nanosheets were converted to ZnO porous nanosheets due to the decomposition of Zn5(OH)8Cl2·H2O and oxidation of Zn.

Effects of Preparing Conditions on the Nanostructures Electrodeposited from the Zn(No3)(2) Electrolyte Containing Kcl

Effects of Electrodeposition Electrolyte Concentration on Microstructure, Optical Properties and Wettability of ZnO Nanorods

Preparation and electrochemical corrosion behaviour of 3D large-sized nanocrystalline copper bulk in solutions with chloride ions

Kinetic Analysis on Anodic Polarization Behavior of Nanocrystalline Copper in Na2SO4 Solution

Effect of Electrodeposition Time on Microstructure, Wettability and Optical Properties of ZnO Nanorod Arrays

Effects of preparing conditions on the electrodeposition of well-aligned ZnO nanorod arrays

Effect of solution concentration on surface morphology, optical properties and solar light response of ZnO thin films

The effect of supporting electrolyte concentrations on the growth of nickel nanostructures

Mechanism of the Electrodeposition of ZnO Nanosheets below Room Temperature

Effect of alkali metal hydroxide on formation processes of zinc oxide crystallites from aqueous solutions containing Zn(OH)42? ions

Substrate effect on Electrodeposition of ZnO nanorod Arrays

Effect of Preparation Condition on Electrochemical Property of Nano-Nickel Powders

Morphological control of ZnO nanostructures by electrodeposition.

Well Ordered Hollow Urchin-Like ZnO by Electrodeposition

Effect of EDTA and NH 4 Cl additives on electrodeposition of Zn–Ni films from choline chloride-based ionic liquid

Effects of the electrochemical deposition conditions on the properties of ZnO polycrystalline thin film

Preparation of microstructured ZnO nanorod photoelectrode

Effects of additive NaI on electrodeposition of Al coatings in AlCl3-NaCl-KCl molten salts

Preparation of ZnS Hollow Nanostructures Using ZnO Nanostructures As Precursors

Effects of processing technology on the electrochemical behavior and Zn deposition process of Al-Mn-Ca alloy cathodes in high Cl− ions ZnSO4 solutions

Effect of precursor solution temperature on the morphology and electrochemical performance of electrodeposited MnO2 nanofilms for lithium-ion batteries