Abstract:ABSTRACT:Objective To develop corrosion electrochemistry method with spatial resolution.Methods Pure Ni and Ni-P alloy coatings on copper substrates were fabricated by electrodeposition. Scanning Electron Microscopy (SEM) and XRD were applied to check surface morphology and crystal structure of the alloy coatings. Scanning Electrochemical Microscopy (SECM) research was applied to monitor the failure behavior of typical Ni and Ni-P coating in different concentration of NaCl solution. Combined with COMSOL Multiphysics simulation, 2D and 3D models were built to quantify activity point size and feedback mechanism.Results The low concentration of chloride ion had the activation effect for pure Ni coating, while higher chloride ion concentration promoted corrosion occurrence. Ni-P alloy coating maintained good stability in a short immersion time in low concentration of chloride in the solution. After 6 hours soaking, there were typical active points and corrosion products for low P alloy coating, while after 24 hours soaking for high P alloy coating. The corrosion type for low P alloy coating in 0.1 mol/L NaCl solution was localized corrosion and uniform corrosion in 0.3 mol/L NaCl solution. The simulation results of approaching curve showed that the electrochemical process of corrosion products for FcMeOH was completely inert and fresh Cu surface was electrochemical activity. 3D simulation results showed that active points of Ni-P coating failure process were close to 10 micron. Conclusion The failure process including the formation of active points, the generation and accumulation of corrosion production of Ni and Ni-P coating in NaCl solution is dependent on the positive and/or negative feedback effect of SECM map-ping. Chloride ion promotes occurrence of corrosion process, and its concentration has a strong effect on the corrosion type for Ni-P coating. COMSOL multiphysics simulation results indicate that the feedback effect is strongly dependent on the distance between the tip and the substrate, and the size of active point for Ni-P coating is micron level.

Preparation and electrochemical corrosion behaviour of 3D large-sized nanocrystalline copper bulk in solutions with chloride ions

Electrochemical Corrosion Behavior and Surface Passivation of Bulk Nanocrystalline Copper in Alkaline Solution

Electrochemical corrosion behavior of nanocrystalline copper bulk

Effect of Sulfate Ions on Anodic Polarization Behavior of Nanocrystalline Copper Bulk

Electrochemical Corrosion Behavior of Bulk Nanocrystalline Copper in Nitric Acid Solution

Corrosion Behavior of Bulk Nanocrystalline Copper in Ammonia Solution

Effect of Grain Size on Corrosion of Nanocrystalline Copper in NaOH Solution

Kinetic Analysis on Anodic Polarization Behavior of Nanocrystalline Copper in Na2SO4 Solution

Influence of cryogenic impacting and succeeding annealing on electrochemical corrosion behavior of coarse-grain Cu bulk in sodium chloride solution

The Effect of Chloride Ion on Corrosion Behavior of Ni-P Alloy Coating Using SECM Experiment and COMSOL Simulation

Corrosion Behaviour of Copper under Chloride-Containing Thin Electrolyte Layer

Electrochemical Behaviors of Ni-Base Superalloy CMSX-4 in 3.5 wt.% NaCl: Effect of Temperature and Preoxidation

Study on the Initial Atmospheric Corrosion Behavior of Copper in Chloride-Containing Environments

Enhanced Corrosion Resistance of a Cu10Ni Alloy in a 3.5 Wt% NaCl Solution by Means of Ultrasonic Surface Rolling Treatment

Systematic Insight into Chloride Concentration, Applied Potential and Time Effect on the Passive Film of Cu-Zn-Ni Ternary Alloy in Alkaline Solution

Multi-scale study on the electrochemical behavior and corrosion mechanism of 5083 aluminum alloy with different microstructures in a NaCl environment

Study on electrodeposition behaviour and corrosion resistance of nickel-copper alloy in ChCl-EG deep eutectic solvents

Nanoscale Intergranular Corrosion and Relation With Grain Boundary Character as Studied In Situ on Copper

Electrodeposition and Corrosion Behavior of Nanocrystalline Aluminum from A Chloroaluminate Ionic Liquid

Microstructure and Corrosion Behavior of Electrodeposited Nickel Prepared from a Sulphamate Bath

Corrosion behavior of FeCoNiCrCux high-entropy alloys in 3.5% sodium chloride solution