Abstract:Unlike the dual-layer membranes in which dual-layers attached tightly after co-casting, the attainment of independent poly (vinylidene fluoride) (PVDF) membranes with uniformly rough surface structures necessitates the delamination of top-layer membranes from the underlying PVDF membranes. The coverage of top-layer membranes via co-casting is expected to reduce the solvent/nonsolvent exchange rate for the underlying PVDF membranes during a phase inversion process. In this context, a polyethersulfone (PES) membrane was cocast onto a PVDF membrane followed by phase inversion in a water bath to fabricate PVDF membranes for membrane distillation (MD). The spontaneous delamination of PES from PVDF membranes occurs once the membrane solidifies. Due to the combined effect of the additional PES layer and the solvent retained at the PES/ PVDF interface, delayed liquid-liquid (L-L) demixing and crystallization of the PVDF solution take place during the phase separation process, resulting in the formation of a porous surface with symmetric cross-section. Results show that the PVDF concentration significantly affects the membrane morphology. Increasing the PVDF content from 16 wt% to 20 wt% leads to a marked morphological change for membrane cross-section from cellular pores to PVDF particles, which indicates that the phase inversion mechanism varies from delayed L-L demixing to solidliquid (S-L) demixing; this is mainly affected by the solution viscosity. Due to the roughness increment by the particulate surfaces, the hydrophobicity of co-cast PVDF membranes (PVDF-co) is distinctly enhanced compared to the single-layer PVDF membranes. Furthermore, the pore sizes of the PVDF-co membranes are enlarged, and the thicknesses are reduced. Therefore, the PVDF-co membranes have much higher fluxes than the single-layer PVDF membranes, especially for PVDF-co-20 membranes composed of large PVDF particles which show superior pore interconnectivity than the cellular pores. A long-term stability test is conducted with the PVDF-20-21 membrane for 48 h using a 3.5 wt% NaCl solution at the feed and permeate temperatures of 60 C and 20 C, respectively. Fairly steady fluxes are observed over the testing course, as well as a continuous high salt rejection of above 99.95%

Gelling and phase inversion preparation for Al2O3/PVDF hybrid membrane

The Polymer-rich Phase Solidification Process of PVDF-PVP-DMAc-H2O Solution

Effects of Preparing Condition on PVDF Membrane Morphology

Influence of additives on phase separation process of PVDF solution and membrane morphology

In Situ Crosslinking of Hyperbranched Polyglycerol in Casting Solutions and Its Effect on the Structure and Properties of Porous Pvdf Membranes

Preparation of Porous PVDF Membrane Via Thermally Induced Phase Separation with Diluent Mixture of DBP and DEHP

Porous PVDF membranes containing amphiphilic comblike polysiloxane formed via phase inversion process

Porous Membranes Modified by Hyperbranched Polymersi. Preparation and Characterization of PVDF Membrane Using Hyperbranched Polyglycerol As Additive

Preparation of PVDF/Al2O3 hybrid membrane via the sol-gel process and characterization of the hybrid membrane

Polymorphism in Porous Poly(vinylidene Fluoride) Membranes Formed Via Immersion Precipitation Process

INFLUENCE OF ALCOHOL-BASED NONSOLVENTS ON THE FORMATION AND MORPHOLOGY OF PVDF MEMBRANES IN PHASE INVERSION PROCESS

Preparation of PVDF/Al2O3 hybrid membrane via alkaline modification and chemical coupling process

Relationship Between Polymers Compatibility and Casting Solution Stability in Fabricating PVDF/PVA Membranes

Preparation and Characterization of Hybrid PVDF/Al2O3 Membrane

Study on PVDF Ultrafiltration Membrane Experiment Preparation and Membrane Formation Mechanism

Stability of Nano-Al_2O_3 Sol and Properties of PVDF/Al_2O_3 Hybrid Membrane

Influence of Dope Viscosity on the Fabrication of Pvdf Hollow Fiber Membranes with Single Skin Layer

In Situ Preparation of Al-containing PVDF Ultrafiltration Membrane Via Sol-Gel Process.

A Co-Casting Route Enables the Formation of Skinless, Hydrophobic Poly (vinylidene Fluoride) Membranes for DCMD

The effect of casting solution composition on surface structure and performance of poly(vinylidene fluoride)/multi-walled carbon nanotubes (PVDF/MWCNTs) hybrid membranes prepared via vapor induced phase separation

Preparation of Ipp Hollow-Fiber Microporous Membranes Via Thermally Induced Phase Separation with Co-Solvents of DBP and DOP