Abstract:The membrane formation mechanism of PVDF/DMAc/H2O/Additive system was studied. The additive was PVP, PEG or LiCl respectively. The phase diagram for polymer solution of PVDF/DMAc/Water/Additive system was measured using cloud-point method. The phase separation phenomena during membrane formation process were recorded using light transmission experiment. The crystallinity of membrane was detected by DSC. The result shown both gelation and liquid-liquid demixing existed during phase-inversion process of casting solution with different additive. Gelation appeared early at lower nonsolvent concentration than liquid-liquid demixing in the range of 30 ∼ 60°C. LiCl as additive lead to a strong action for PVDF solution to form gel than PEG or PVP. This increased the mass transfer resistance in nascent membrane and the liquid-liquid demixing delayed time prolonged along with the sequence of PVP, PEG or LiCl as additive during membrane formation process. The polymer concentration of nascent membrane at the onset of liquid-liquid demixing increased and restricted the development of macrovoids. The strong gelation tendency of polymer solution intensified the solidification of nascent membrane and restricted the macrovoids development further. Thus the macrovoids structure extended to the bottom and stopped with the sponge-like structure when PVP was used as additive. When the additive was PEG or LiCl, the macrovoids developed insufficiently and terminated in the middle of membrane with the sponge-like structure and then passed to nodular structure in bottom. The effective porosity and flux decreased and crystallinity increased along with the sequence of PVP, PEG or LiCl as additive. The hydrophobicity of membrane with LiCl as additive was barely changed, but the water-resisting pressure of membrane with PVP or PEG as additive decreased about 20 kPa.

Morphology and Formation Mechanism of Poly(Vinylidene Fluoride) Membranes Prepared with Immerse Precipitation: Effect of Dissolving Temperature

Polymorphism in Porous Poly(vinylidene Fluoride) Membranes Formed Via Immersion Precipitation Process

Formation Mechanism and Crystallization of Poly(vinylidene Fluoride) Membrane Via Immersion Precipitation Method

Effect of Dissolving Temperature of Dopes on the Morphology of PVDF Membrane

Effects of Preparing Condition on PVDF Membrane Morphology

Effect of Coagulation Bath Temperature on Formation Mechanism of Poly(vinylidene Fluoride) Membrane

Influence of Solvents on the PVDF Membrane Properties

Morphology, Crystallization and Formation Mechanism of Poly(Vinylidene Fluoride) Membranes Prepared with Immersion Precipitation: Effect of Maturation Time

Preparation of Porous PVDF Membrane Via Thermally Induced Phase Separation with Diluent Mixture of DBP and DEHP

Influence of additives on phase separation process of PVDF solution and membrane morphology

Effect of Polymer Molecular Weight on the Morphology and Crystallization of Prepared PVDF Membranes

Effect of Preparation Conditions on the Morphology, Polymorphism and Mechanical Properties of Polyvinylidene Fluoride Membranes Formed Via Thermally Induced Phase Separation

Formation of Poly(vinylidene Fluoride) (PVDF) Membranes Via Thermally Induced Phase Separation

Effect of Maturation Time of Dopes on the Morphology and Crystallization of PVDF Membranes

Controlling the Morphology and Crystal Form of Symmetric Network PVDF Membranes by Bath Temperature

INFLUENCE OF ALCOHOL-BASED NONSOLVENTS ON THE FORMATION AND MORPHOLOGY OF PVDF MEMBRANES IN PHASE INVERSION PROCESS

Effect of Temperature on the Formation of Microporous PVDF Membranes by Precipitation from 1-Octanol/DMF/PVDF and Water/DMF/PVDF Systems

Effect Of Preparation Methods On Crystallization Behavior And Tensile Strength Of Poly(Vinylidene Fluoride) Membranes

The Effects of Processing Conditions on the Surface Morphology and Hydrophobicity of Polyvinylidene Fluoride Membranes Prepared Via Vapor-Induced Phase Separation

Morphologies and crystalline forms of polyvinylidene fluoride membranes prepared in different diluents by thermally induced phase separation

Effects of coagulation bath composition on structure and morphology of PVDF membrane prepared by thermal induced phase separation method