Abstract:Gel polymer electrolyte with high ionic conductivity and high lithium ion transference number for lithium-ion batteries attracts unremitting pursuit of scientists. For that, we develop a novel strategy of one-step reactive vapor-induced phase separation (RVIPS) to fabricate a porous polymer electrolyte (PPE) membrane from poly(vinylidene fluoride-hexafluoropropylene) (PVDF-HFP). The polymer and a salt of lithium bis(trifluoromethanesulfonyl) imide (LiTFSI) were first mixed in acetone, then the solution was cast under an ammonia water atmosphere to evaporate solvent. The porous microstructure of the obtained PPE membrane was carefully analyzed and was compared with that of the PPE membrane prepared under water vapor of a usual VIPS. Moreover, the electrochemical properties of the PPE membranes were measured. Our results indicate that the reactive vapor of ammonia water induced dehydrofluorination of PVDF-HFP to result in its cross-linking. The cross-linking together with the plasticizer effect of the incorporated LiTFSI suppresses the crystallization of PVDF-HFP, while enhancing the flexibility of the polymer chain segments. As a result, the PPE membrane containing 10% LiTFSI displays interconnected pores and takes up 240% liquid electrolyte, so as to possess an ionic conductivity as high as 1.32 × 10 –3 S cm −1 at 30 oC. In addition, battery tests demonstrate a high-rate ability and excellent cycle performance of the PPE membrane fabricated via the RVIPS. An initial capacity of 128 mAh∙g −1 , 97.7% capacity retention and 99.9% Coulombic efficiency at 1C after 120 cycles of the cell equipped with the PPE membrane undoubtedly indicate its promising potential.

Preparation Of Pvdf/P(Mma-Co-Pegma) Porous Membranes Via Phase Inversion Process For Gel Polymer Electrolyte

Preparation and Properties of Gel Membrane Containing Porous PVDF-HFP Matrix and Cross-Linked PEG for Lithium Ion Conduction

Preparation and Characterization of PVDF/P（MMA-co-DMAEMA） Separators for Lithium Battery

Lithium ion conducting gels containing porous PVDF-HFP matrix filled with crosslinked PEG

Preparation of PVDF- HFP Porous Membrane Via Thermally Induced Phase Separation and Application in Lithium Ion Battery

Effects of PDMS with Polyether Side Chains on the Fluoropolymer Based Gel Lithium Electrolytes

Gel-filling polymer electrolytes based on porous PVDF membrane for rechargeable lithium batteries

Effect of Amphiphilic Hyperbranched-Star Polymer on the Structure and Properties of Pvdf Based Porous Polymer Electrolytes

Fumed silica-doped poly(butyl methacrylate-styrene)-based gel polymer electrolyte for lithium ion battery

Novel Configuration of Polyimide Matrix-Enhanced Cross-Linked Gel Separator for High Performance Lithium Ion Batteries

Preparation and Characterization of Safety Pvdf/P(Mma-Co-Pegma) Active Separators by Studying the Liquid Electrolyte Distribution in This Kind of Membrane

Preparation and Properties of Poly (vinylidene Fluoride)/poly(dimethylsiloxane) Graft (poly(propylene Oxide)-Block-poly(ethylene Oxide)) Blend Porous Separators and Corresponding Electrolytes

Preparation Of Poly (Dimethylsiloxane) Graft (Poly(Propylene Oxide)-Block-Poly (Ethylene Oxide) Modified Pvdf Separator And Its Use In Lithium Ion Batteries

Preparation and characterization of a novel microporous PE membrane supporting composite gel polymer electrolyte

Creation of Lithium-Ion-Conducting Channels in Gel Polymer Electrolytes Through Non-Solvent-Induced Phase Separation for High-Rate Lithium-Ion Batteries

Complementary Hybrid Design of Solvated Electrolyte Membranes Enabled by Porous Carbon Reinforcement for High-Performance Lithium Batteries

Fabrication of a porous polymer electrolyte from poly(vinylidene fluoride-hexafluoropropylene) via one-step reactive vapor-induced phase separation for lithium-ion battery

Gel polymer electrolyte-based on PVDF/fluorinated amphiphilic copolymer blends for high performance lithium-ion batteries

Preparation of P(AN–MMA) Microporous Membrane for Li-ion Batteries by Phase Inversion

Preparation of Pvdf/Pmma Blend Microporous Membranes for Lithium Ion Batteries Via Thermally Induced Phase Separation Process

Gel polymer electrolytes based on active PVDF separator for lithium ion battery. I: Preparation and property of PVDF/poly(dimethylsiloxane) blending membrane