Abstract:In this paper, the composite membranes based on poly(vinylidene fluoride) (PVDF) with different amounts of halloysite (HNT) nano-filler were prepared by phase inversion method for the application of lithium ion batteries. The effect of the content of HNT on the crystallinity and morphology of the composite membranes were investigated. The results showed that the crystallization behaviors of the HNT/PVDF composite membranes were reduced with the increase of HNT filler content. Furthermore, the introduction of HNT into PVDF matrix remarkably affected the formation rate of nuclei which could evolve into pores to change surface morphology. The HNT/PVDF composite membranes showed the sufficient porosity and good affinity between the eletrolyte as well as the electrode, which led to superb electrolyte uptake and low interfacial impedance. Among HNT/PVDF composite membranes, in particular, the 4-HNT/PVDF composite membrane with 4 wt% HNT content had a great electrolyte uptake (430.2%), superior electrochemical stability window (4.5 V), high ionic conductivity (2.4 mS/cm), and low interfacial impedance (63 Omega). The cells assembled with the 4-HNT/PVDF composite membranes obtain discharge capacities of 164.72 mAh/g (0.1C) and 134.88 mAh/g (2C), corresponding to 96.89% and 79.34% of the theoretical capacity of LiFePO4 (170 mAh/g), respectively, better cycle performance (with capacity retention 89.12% after 100 cycles) at 0.5C and excellent rate performance. It is concluded that the content of HNT deeply affects membrane performance. Therefore, the 4-HNT/PVDF composite membranes could be a good option of high performance lithium ion batteries. (C) 2019 Elsevier B.V. All rights reserved.

Preparation of PVDF- HFP Porous Membrane Via Thermally Induced Phase Separation and Application in Lithium Ion Battery

MICROPOROUS PVDF-HFP-BASED POLYMER MEMBRANES FORMED FROM SUPERCRITICAL CO2 INDUCED PHASE SEPARATION *

PVDF porous matrix with controlled microstructure prepared by TIPS process as polymer electrolyte for lithium ion battery

Preparation and Properties of Gel Membrane Containing Porous PVDF-HFP Matrix and Cross-Linked PEG for Lithium Ion Conduction

Preparation Of Pvdf/P(Mma-Co-Pegma) Porous Membranes Via Phase Inversion Process For Gel Polymer Electrolyte

Effects of PDMS with Polyether Side Chains on the Fluoropolymer Based Gel Lithium Electrolytes

Preparation and Characterization of PVDF/P（MMA-co-DMAEMA） Separators for Lithium Battery

Gel-filling polymer electrolytes based on porous PVDF membrane for rechargeable lithium batteries

Investigation on PVDF-HFP microporous membranes prepared by TIPS process and their application as polymer electrolytes for lithium ion batteries

PVDF-HFP membrane prepared via TIPS process as the matrix of gel electrolyte for lithium ion battery

Preparation of Pvdf/Pmma Blend Microporous Membranes for Lithium Ion Batteries Via Thermally Induced Phase Separation Process

Fabrication of Polysulfone Membrane Via Thermally Induced Phase Separation Process

Preparation of Halloysite/polyvinylidene Fluoride Composite Membrane by Phase Inversion Method for Lithium Ion Battery

PVDF-HFP-based porous polymer electrolyte membranes for lithium-ion batteries

Preparation of PVDF/PEO-PPO-PEO blend microporous membranes for lithium ion batteries via thermally induced phase separation process

Preparation of PVDF-HFP Microporous Membranes via the Thermally Induced Phase Separation Process

Preparation of PVDF Based Blend Microporous Membranes for Lithium Ion Batteries by Thermally Induced Phase Separation: I. Effect of PMMA on the Membrane Formation Process and the Properties

Study on PVDF-HFP polymer membranes prepared by wet process

Enhanced Ionic Conductivity and Electrochemical Capacity of Lithium Ion Battery Based on PVDF-HFP/HDPE Membrane

Preparation Of Poly (Dimethylsiloxane) Graft (Poly(Propylene Oxide)-Block-Poly (Ethylene Oxide) Modified Pvdf Separator And Its Use In Lithium Ion Batteries

Preparation of PVDF–HFP microporous membrane for Li-ion batteries by phase inversion