Abstract:This work aims exploring the high performance porous separators that can be activated into gel electrolyte membranes for lithium ion batteries. A comb-like copolymer poly (dimethylsiloxane) graft poly (propylene oxide)-block-poly (ethylene oxide) (PDMS-g-(PPO-PEO)) was synthesized and blended with poly (vinylidene fluoride) (PVDF) to fabricate porous separators via a typical phase inversion process, and then the separators absorbed liquid electrolyte solution and formed into polymer electrolyte membranes. By measuring the composition, morphology and ion conductivity etc, the influence of PDMS-g-(PPO-PEO) on structure and properties of blend separators were discussed. Compared with pure PVDF separator with comparable porous structure, the adoption of PDMS-g-(PPO-PEO) decreased the crystallinity and increased the liquid electrolyte uptake and stability effectively. It was also found that the electrode/electrolyte interfacial resistance could be reduced greatly. The resulting electrolyte membrane using separator with PVDF/PDMS-g-(PPO-PEO) mass ratio in 8/2 exhibited highest ionic conductivity in 4.5 x 10(-3) S/cm at room temperature, while the electrochemical stability was up to 4.7 V (vs. Li/Li+). Coin cells assembled with such separators also exhibited stable cycle performance and improved rate capabilities, especially when discharge rate higher than 0.5 C. (C) 2013 Elsevier Ltd. All rights reserved.

MICROPOROUS PVDF-HFP-BASED POLYMER MEMBRANES FORMED FROM SUPERCRITICAL CO2 INDUCED PHASE SEPARATION *

Preparation of PVDF- HFP Porous Membrane Via Thermally Induced Phase Separation and Application in Lithium Ion Battery

Preparation and Characterization of PVDF‐HFP Membrane

Effect of solvent concentration on development of macrovoids of PVDF phase-diversion membranes

Preparation of Porous PVDF Membrane Via Thermally Induced Phase Separation with Diluent Mixture of DBP and DEHP

Preparation Of Pvdf/P(Mma-Co-Pegma) Porous Membranes Via Phase Inversion Process For Gel Polymer Electrolyte

Preparation and Characterization of Pvdf-Hfp Microporous Membrane by Template Method

Polymorphism in Porous Poly(vinylidene Fluoride) Membranes Formed Via Immersion Precipitation Process

Investigation on PVDF-HFP microporous membranes prepared by TIPS process and their application as polymer electrolytes for lithium ion batteries

Microstructure of Poly(Vinylidene Fluoride)-Based Polymer Electrolyte and Its Effect on Transport Properties

Preparation of PVDF-HFP Microporous Membranes via the Thermally Induced Phase Separation Process

Preparation of Pvdf/Pmma Blend Microporous Membranes for Lithium Ion Batteries Via Thermally Induced Phase Separation Process

Preparation and Properties of the Composite Microporous PVDF-HFP/SiO2 Based Polymer Electrolytes

Fabrication of Hydrophilic and Sponge-Like PVDF/brush-like Copolymer Blend Membranes Using Triethylphosphate As Solvent

Structure and ionic conductivity of porous polymer electrolytes based on PVDF-HFP copolymer membranes

PVDF-HFP-based porous polymer electrolyte membranes for lithium-ion batteries

Preparation and Properties of Poly (vinylidene Fluoride)/poly(dimethylsiloxane) Graft (poly(propylene Oxide)-Block-poly(ethylene Oxide)) Blend Porous Separators and Corresponding Electrolytes

Preparation and Characterization of PVDF-HFP-based Polymer Electrolyte

Microstructure of Microporous Polyvinylidene Fluoride Membrane Prepared Via Thermally Induced Phase Separation

PREPARATION AND ELECTROCHEMICAL CHARACTERISTICS OF POLYMER ELECTROLYTE MEMBRANES BASED ON SAN/PVDF-HFP BLENDS

Preparation of PVDF–HFP microporous membrane for Li-ion batteries by phase inversion