Abstract:In order to clarify the magnetic-thermal-force changing rule of high-frequency transformers under different winding arrangements, this paper tests the magnetization and loss characteristics of nanocrystalline materials at different temperatures, and based on the magnetization and loss data, establishes a magnetic-thermal-force coupling calculation model of 15 kVA, 5 kHz nanocrystalline high-frequency transformers, and calculates and analyzes the magnetic flux density, loss and temperature rise distributions of high-frequency transformers with three different winding arrangements under no-load and short-circuit conditions, respectively. Through comparative analysis, it was found that under no-load conditions, the cross-transposition of winding has less influence on the magnetic flux of the high-frequency transformer core, but it can reduce the iron-core loss and transformer temperature rise. The cross-transposition of winding under short-circuit conditions can significantly reduce the leakage magnetic field strength of high-frequency transformers; complete cross-transposition weakens the high-frequency transformer losses and temperature rise better than partial cross-transposition. According to the winding current density and core leakage field distribution under short-circuit conditions, we calculated and analyzed the distribution of its the axial and radial electromagnetic forces. The results show that the axial electromagnetic force causes the winding to be squeezed from both ends to the middle, the radial electromagnetic force causes the primary winding to shrink inward and the secondary winding to expand outward, so cross-transposition can greatly reduce electromagnetic force and weakening the deformation of the winding. Therefore, high-frequency transformers of winding cross-transposed should be used in actual projects to reduce transformer temperature rise and improve efficiency and security. This research has theoretical significance for the multi-physical field coupling of high-frequency transformers and its structural design.

Testing of High Current Transformer by Non-Uniform Equivalent Magnetomotive Force Method

Design Method of Non-uniformly Distributed Winding for Anti-interference Equivalent Test of Heavy Current Transformers

Research on Magnetic Field of Current Transformer under Non Uniformly-Distributed Equal Ampere-turns Test

Calculation Method of Winding Eddy-Current Losses for High-Voltage Direct Current Converter Transformers

Eccentric bus-bar testing method of the shielding effect of heavy current transformer with shielding coils

The Numerical Simulation Method of Transformer Internal Short-Circuit Fault

Analysis on eccentric bus-bar testing method of heavy current transformer

New Testing Method of the Shielding Effect of Heavy Current Transformer with Shielding Coils

Design Of Equivalent Coils For Anti-Interference Testing Of Heavy Current Transformers

Dynamic Electromagnetic Force Analysis of a Power Transformer with Regulated Windings

3D FEM Computation of Magnetic Field of Heavy Current Transformer with Shielding Coils

On-line Demagnetization Method for an Iron Core CT

Novel Test Method for AC Current-Carrying Capability in the Consideration of Alternating Magnetic Field

Equivalent testing methods for shielding of heavy protective current transformers

Eccentric Bus-Bar Testing Method of the Shielding Effect of a Heavy Current Transformer With Shielding Coils

Research on Magnetic-Thermal-Force Multi-Physical Field Coupling of a High-Frequency Transformer with Different Winding Arrangements

An Inductance Testing Method of Dual Three-phase Permanent Magnet Synchronous Machines Using Equivalent Electromagnetic Field Analysis

The Analysis and Equivalent Method of Five-Phase Current Stray Magnetic Field in Heavy Current Transformer

A FEM-based simulation of electromagnetic forces on transformer windings under short-circuit

Research on the Methods of Measuring High Frequency Small Current in Large Power Frequency Current by Current Transformer

Method for Measuring the Exciting Current of Current Transformers by Using an Auxiliary Winding