Abstract:Purpose This paper aims to develop a model that reflects the current transformer (CT) core materials nonlinearity. The model enables simulation and analysis of the CT excitation current that includes the inductive magnetizing current and the resistive excitation current. Design/methodology/approach A nonlinear CT model is established with the magnetizing current as the solution variable. This model presents the form of a nonlinear differential equation and can be solved discretely using the Runge–Kutta method. Findings By simulating variations in the excitation current for different primary currents, loads and core materials, the results demonstrate that enhancing the permeability of the B–H curve leads to a more significant improvement in the CT ratio error at low primary currents. Originality/value The proposed model has three obvious advantages over the previous models with the secondary current as the solution variable: (1) The differential equation is simpler and easier to solve. Previous models contain the time differential terms of the secondary current and excitation flux or the integral term of the flux, making the iterative solution complicated. The proposed model only contains the time differential of the magnetizing current. (2) The accuracy of the excitation current obtained by the proposed model is higher. Previous models calculate the excitation current by subtracting the secondary current from the converted primary current. Because these two currents are much greater than the excitation current, the error of calculating the small excitation current by subtracting two large numbers is greatly enlarged. (3) The proposed model can calculate the distorted waveform of the excitation current and error for any form of time-domain primary current, while previous models can only obtain the effective value.

Method for Measuring the Exciting Current of Current Transformers by Using an Auxiliary Winding

Calculation Method of Winding Eddy-Current Losses for High-Voltage Direct Current Converter Transformers

Online Measurement Method and System of Excitation Impedance of Current Transformers Based on Norton's Theorem and Differential Method to Measure Difference of Two Currents

Online Measurement Method and System of Excitation Impedance of Current Transformers Based on Norton’s Theorem and Differential Method to Measure Difference of Two Currents

Introduction of an intriguing approach for eletric current transformer on-site examining repairing

Study of the Heavy Direct Current Indirect Measurement and Calculation Based on the Waveform Measuring of Valve Currents

Approach of Obtaining the Error of Current Transformers Through the Measurement of Turns Correction Factor and Impedance

A Novel Method for DC Current Measurement Using Current Transformer

Modeling Method of High-frequency Equivalent Circuit of Current Transformer for Overvoltage Detection

Modeling and Simulation Analysis of Current Transformer Based on Magnetizing Current As the Solution Variable

Testing of High Current Transformer by Non-Uniform Equivalent Magnetomotive Force Method

A Novel Current Transformer Based on Virtual Air Gap and Its Basic Measuring Characteristics

Study of Current Measurement Method Based on Circular Magnetic Field Sensing Array

High-frequency Equivalent Circuit Modeling for Overvoltage Detection

On-line Demagnetization Method for an Iron Core CT

A High-Precision Error Calibration Technique for Current Transformers under the Influence of DC Bias

In-Situ Measurement and Investigation of Winding Loss in High-Frequency Cored Transformers Under Large-Signal Condition

The Development and Performance of Dual-Core DC Tolerant Current Transformer

Study on the Currents of Two-stage Current Transformer under the Small Secondary Current Method

A Novel Method for Current Transformer Saturation Countermeasure Based on Comparing Two Currents' Polarities

On-line Measurement for Power Angle and Circuit Parameter in the Turbo Steam Generator with the FEM Based