Abstract:In this paper, a low power transceiver for wireless sensor networks (WSN) is proposed. The system is designed with fully functional blocks including a receiver, a fractional-N frequency synthesizer, and a class-E transmitter, and it is optimized with a good balance among output power, sensitivity, power consumption, and silicon area. A transmitter and receiver (TX-RX) shared input-output matching network is used so that only one off-chip inductor is needed in the system. The power and area efficiency-oriented, fully-integrated frequency synthesizer is able to provide programmable output frequencies in the 2.4 GHz range while occupying a small silicon area. Implemented in a standard 0.18 μm RF Complementary Metal Oxide Semiconductor (CMOS) technology, the whole transceiver occupies a chip area of 0.5 mm2 (1.2 mm2 including bonding pads for a QFN package). Measurement results suggest that the design is able to work at amplitude shift keying (ASK)/on-off-keying (OOK) and FSK modes with up to 500 kbps data rate. With an input sensitivity of −60 dBm and an output power of 3 dBm, the receiver, transmitter and frequency synthesizer consumes 2.3 mW, 4.8 mW, and 3.9 mW from a 1.8 V supply voltage, respectively.

Low Voltage Low Power Up-Conversion Mixer for Wireless Sensor Networks Node Application

A 11 Mw 2.4 GHz 0.18 Μm CMOS Transceivers for Wireless Sensor Networks

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

A 2.4ghz Low Power Highly Linear Mixer For Direct-Conversion Receivers

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

Low Voltage, Low Power, Downconversion Folded-Switching Mixer With Current-Reuse Technology

A 0.6V 32.5mw Highly Integrated Receiver for 2.4ghz ISM-Band Applications

Design and Analysis of an Ultrawide-Band Distributed Drain-Pumped Mixer Using 0.18µm CMOS Technology

A 5 GHz low power 0.18μm CMOS Gilbert cell mixer

A LOW POWER, HIGH-LINEARITY CMOS DOWNCONVERSION FOLDED MIXER FOR 2.4GHz ISM BAND APPLICATIONS

A 0.18 Mu M Cmos High Linearity Flat Conversion Gain Down-Conversion Mixer For Uwb Receiver

A New Low Voltage RF CMOS Mixer Design

A Low-Power 2.4-Ghz Receiver Front-End with a Complementary Series Feedback LNA and a Current-Reused Passive Down-Converter Based on Gm-Boosted TIA for WSN Applications.

Optimizing Mixer Noise Performance: A 2.4 Ghz Gilbert Downconversion Mixer for W-Cdma Application

Low Voltage CMOS Gilbert Mixers for Bluetooth Transceiver

A 0.18μm CMOS high linearity flat conversion gain down-conversion mixer for UWB receiver

A 900mhz High Linearity Low Power Down-Conversion Mixer

Low power, high linearity multi-mode downconversion mixer for SDR

Designing of RF Single Balanced Mixer with a 65nm CMOS Technology Dedicated to Low Power Consumption Wireless Applications

A Low Noise High Linearity CMOS Upconversion Mixer

CMOS Mixers for 2.4GHz WLAN Transceivers