Abstract:To explore the gasification characteristics of brewer's spent grains (BSGs) in a fluidized bed gasifier with air and water vapor as gasification agents, a numerical simulation model with computational particle fluid dynamics (CPFD) of 3D bubbling fluidized-bed gasifier was established, and gasification properties was investigated based on CPFD simulation. The thermogravimetric mass spectrometry (TG-MS) was used to investigate the main components in the volatiles released during the pyrolysis of BSGs, for providing benchmark data of gasification raw materials. The effects of temperature T, equivalence ratio ER, steam-to-BSGs mass ratio S/B and fluidization velocity u(g) on the gasification properties, were investigated using CPFD analysis. The results showed that when the gasification temperature increased from 700 degrees C to 900 degrees C, the mole fractions of CO and H-2 in the product gas increased from 9.80 % and 3.95 % to 16.00 % and 14.21 % respectively, and the low heating value of the product gas increased from 3.36 MJ center dot Nm(-3) to 4.35 MJ center dot Nm(-3). As ER value increased from 0.2 to 0.4, the carbon conversion fraction increased from 78.8 % to 85 %, but the molar fractions of H-2 and low heating value of the product gas both decreased. When S/B value increased from 0.3 to 0.7, the molar fraction of H-2 increased from 6.54 % to 11.76 %, while the molar fraction of CO and CH4 decreased from 13.59 % and 3.97 % to 11.37 % and 3.84 % respectively. With u(g) value increasing from 0.15 m center dot s(-1) to 0.75 m center dot s(-1), the molar fraction of H-2 and CO increased from 8.11 % and 9.61 % to 11.63 % and 17.01 % respectively, owing to strengthened particle mixing. However, with further increase of u(g), the molar concentrations of H-2 and CO above the splash zone both decreased, due to a portion of BSGs particles being brought out by fluidizing gas from the top outlet of the gasifier. The numerical simulation results were validated by the experiments in a bubbling fluidized-bed gasifier. They underestimated CO2 production, slightly overestimated the mole fraction of H-2 with a maximum error of 9.54 %, overestimated the mole fraction of CO in the vast majority of cases, and estimated the mole fraction of CH4 with a maximum error of only 6.67 %.

Simulation of Biomass-To-Sng Process Via Pressurized Interconnected Fluidized Beds

Review on Biomass Fluidized Bed Combustion/Gasification Sintering Characteristic and Mechanism

Multi-Scale Simulation of Biomass Gasification in Fluidized Beds

Numerical Simulation and Multi-Process Coupling Analysis for Biomass Pyrolysis Fluidized Bed Reactor Based on Synergistic Effects Between Biomass and Nitrogen Inlet Modes

Effects of operating conditions and reactor structure on biomass entrained-flow gasification

Modeling and Simulation of Biomass Air-Steam Gasification in a Fluidized Bed

Simulation of Biomass-Steam Gasification in Fluidized Bed Reactors: Model Setup, Comparisons and Preliminary Predictions

Numerical Simulation of Biomass Gasification in a Bubble Fluidized Bed

Numerical simulation of gasification characteristics in a circulating fluidized bed biomass gasifiers

Modelling and Simulation of Biomass Conversion Processes

Numerical study on biomass model compound gasification in a supercritical water fluidized bed reactor

Biomass Gasification for Syngas and Biochar Co-Production: Energy Application and Economic Evaluation

CPFD Modeling of Air-Steam Gasification of Brewer’s Spent Grains in a Bubbling Fluidized Bed

Comparison and Analysis of Mainstream Methanation Process of Coal-to-SNG Based on Simulation by Aspen Plus

Technical and Economic Assessments of a novel biomass-to-synthetic natural gas (SNG) process integrating O2-enriched air gasification

Simulation of Two-Phase Flow and Syngas Generation in Biomass Gasifier Based on Two-Fluid Model

Modeling Biomass Gasification in Circulating Fluidized Beds

Simulation of Biomass Gasification and Application in Pilot Plant

An Experimental And Response-Surface-Based Optimization Approach Towards Production Of Producer Gas In A Circulating Fluidized Bed Gasifier Using Blends Of Renewable Fibre-Based Biomass Mixtures

CPFD modeling of air-steam gasification of brewer's spent grains in a bubbling fluidized bed

An Efficient Biomass and Renewable Power-to-gas Process Integrating Electrical Heating Gasification