Experimental and simulation studies of oxygen-blown, steam-injected, entrained flow gasification of lignin
Nastaran Samani,Roger Khalil,Morten Seljeskog,Jørn Bakken,Rajan K. Thapa,Marianne S. Eikeland
DOI: https://doi.org/10.1016/j.fuel.2023.130713
IF: 7.4
2024-01-06
Fuel
Abstract:This article presents results from experimental and simulation studies on a laboratory-scale pressurized O 2 -blown Entrained Flow biomass gasification Reactor (EFR) using pulverized commercial lignin pellets as feedstock. The primary focus lies in the assessment of the EFR's performance indicators such as the H 2 /CO ratio, the Cold Gas Efficiency (CGE), and the Carbon Conversion Efficiency (CCE). The gasifier was operated at an absolute pressure of 8.2 bars, with varying amounts of O 2 and steam. In the first series of experiments, the O 2 equivalence ratio varied between 0.2 and 0.8, with no steam injection. This yielded a maximum CGE of 47%, a CCE of 94%, and an H 2 /CO ratio within the range of 0.4–0.7. In the last series of experiments, a perforated horizontal steam tube was installed allowing for a variation of the steam-to-biomass ratio (S/B), between 0.5 and 1.5. At a S/B of 1.5, the CGE and the CCE were at their highest levels of 91% and 99%, respectively. Based on the experimental setup, a 3D multiscale Eulerian-Lagrangian computational particle fluid dynamics (CPFD) model for the reactor was developed and validated against the experimental data. This model was then employed to explore the impacts of reactor temperature, S/B, equivalence ratio (λ), and the lignin particle size distribution (PSD) on the gasification process. The findings show that increased reactor temperature enhances H 2 and CO production. Higher S/B ratios lead to greater H 2 production but reduced CO production. Increased S/B ratios improve both CGE and CCE. Larger particles and higher λ values decrease CO and H 2 production. Without steam injection, the peak CGE occurs at λ ≈ 0.45, corresponding to complete CH 4 conversion. Beyond this point, as λ increases, reactor temperatures rise while CGEs decrease. Simulations reveal the optimal λ range for steam injection is 0.15–0.35. A sensitivity analysis highlights the significant impact of reactor temperature on H 2 and CO production. While λ shows high sensitivity for H 2 production, the S/B ratio exerts a greater impact on CO production.
energy & fuels,engineering, chemical