Abstract:The transformation-assisted consolidation under pressure has been demonstrated to be a promising method to fabricate the nano or submicron polycrystalline ceramic materials. The high pressure suppresses the long-range diffusion of the atoms and, consequently, restrains the grain coarsening. The new phases produced at high pressure could show finer grains under the appropriate thermodynamic conditions, which are not subject to the grain size of the raw materials. Ceramic materials exhibit the existence of the transformations under certain thermodynamic conditions and the formation of new phases generally undergoes the nucleation and growth. In the present work, monoclinic microcrystal ZrO2 with average grain size of 2 µm and Y2O3 with average grain size of 50 nm were mixed in molar ratio of 97∶3. The preparation of the samples was carried out by sintering at 5.5 GPa and temperatures of 800–1700 °C using the high pressure cubic cell, and the sample characterization was performed via the X-ray diffraction, scanning electron microscope and transmission electron microscopy. It was found that the monoclinic and submicron tetragonal composite polycrystalline ZrO2 in bulk is obtained under high pressure and high temperature. The average grain size of tetragonal ZrO2 fabricated at 1200, 1400, 1600 and 1700 °C is (145±62) nm, (246±165) nm, (183±62) nm and (245±107) nm, respectively. The synthesis of the fine-grained polycrystalline materials by the transformation under high pressure can solve the problems of agglomeration, adsorption and grain coarsening caused by the nanopowders as the starting materials in the conventional approach, which would be an alternative route to fabricate the fine-grained polycrystalline materials with the enhanced performances.

Flash Synthesis of Tetragonal-Zro2 Nanostructures by Microwave-Induced Combustion Process

Hydrothermal Synthesis and Characterization of Zirconia Nanocrystallites

Microwave-Assisted Rapid Synthesis Of Zno Hexagonal Quasi-Hourglasses

Fabrication of Submicron Tetragonal Polycrystalline ZrO2 by the Transformation of Micro Monoclinic ZrO2 under High Pressure

Preparation of Nano-ZrO2 powder via a microwave-assisted hydrothermal method

Photoluminescence of Tetragonal ZrO2 Nanoparticles Synthesized by Microwave Irradiation

Spectroscopic studies of metastable tetragonal ZrO2 nanocrystals

Optimization of the structure and morphology of monoclinic phase nanoscale zirconium dioxide

Nano-sized Amorphous Cu–Zr Alloy Particles Prepared by Mechanochemical Reaction

Preparation of Zirconia Powders by Sol-gel Process

Synthesis and Characterization of Zirconium Nitride Nanopowders by Internal Gelation and Carbothermic Nitridation

Synthesis and Pyrolysis Evolution of Glucose-Derived Hydrothermal Precursor for Nanosized Zirconium Carbide

Characterization and Synthesis of Pure Zro2 Nanopowders Via Sonochemical Method

Preparation of ZrO_2 Microspheres Under Microwave Radiation

Preparation and Luminescence of ZrO_2 Nanopowders Via Solvothermal Method

Rapid synthesis of nanocrystalline SnO2 powders by microwave heating method

Doping Effects of Yb3+ on the Crystal Structures, Nanoparticle Properties and Electrical Behaviors of ZrO2 Derived from a Facile Urea-Based Hydrothermal Route

Solvent Effects on the Solvothermal Synthesis of PureMonoclinic and Tetragonal Zirconia Nanoparticles

Synthesis, microstructure and optical characterization of zirconium oxide nanostructures

Co-precipitation of nano Mg–Y/ZrO2 ternary oxide eutectic system: Effects of calcination temperature

Fine Tuning of the Sizes and Phases of ZrO2 Nanocrystals