Abstract:Surface acoustic wave gyroscopes (SAWGs), as a kind of all-solid-state micro-electro-mechanical system (MEMS) gyroscopes, can work normally under extremely high-impact environmental conditions. Among the current SAWGs, amplitude-modulated gyroscopes (AMGs) are all based on the same gyro effect, which was proved weak, and their sensitivity and intensity of the output are both lower than frequency-modulated gyroscopes (FMGs). However, because FMGs need to process a series of frequency signals, their signal processing and circuits are far less straightforward and simple than AMGs. In order to own both high-sensitivity and simple signal processing, a novel surface acoustic traveling wave gyroscope based on amplitude modulation is proposed, using one-dimensional phononic crystals (PCs) in this paper. In view of its specific structure, the proposed gyroscope consists of a surface acoustic wave oscillator and a surface acoustic wave delay line within a one-dimensional phononic crystal with a high-Q defect mode. In this paper, the working principle is analyzed theoretically through the partial wave method (PWM), and the gyroscopes with different numbers of PCs are also designed and studied by using the finite element method (FEM) and multiphysics simulation. The research results demonstrate that under a 1 V oscillator voltage output, the higher sensitivity of -23.1 mV·(rad/s)-1 in the linear range from -8 rad/s to 8 rad/s is reached when the gyro with three PC walls, and the wider linear range from -15 rad/s to 17.5 rad/s with the sensitivity of -6.7 mV·(rad/s)-1 with only one PC wall. Compared with the existing AMGs using metal dots to enhance the gyro effect, the sensitivity of the proposed gyro is increased by 15 to 112 times, and the linear range is increased by 4.6 to 186 times, even without the enhancement of the metal dots.

Sine-Wave Exciting Circuit for Quartz Vibrating Gyroscope

A Quartz Vibrating Gyroscope Interface Circuit Driven by Sine-Wave Based on Nonlinear Multiplier

A Closed-Loop Self-Excited Drive Circuit for Quartz Gyroscope

A High Performance Quartz Vibrating Gyroscope Interface Circuit Driven by Square-Wave

High Performance Interface Circuit for MEMS Gyroscope

A Slot-Structure MEMS Gyroscope Working at Atmosphere With Tunable Electrostatic Spring Constant

Equivalent electrical model for quartz vibrating gyroscope

Mixed Mode Driving Circuit of Quartz Gyroscope Interface Circuit

Synchronous Digital Quadrature Demodulation Technique For Resonant Optic Gyroscopes

Surface Acoustic Wave Gyroscopic Effect in Quartz

Design of A Tuning-Fork Gyro Made of Quartz

Design and Optimization of a Novel SAW Gyroscope Structure Based on Amplitude Modulation with 1-D Phononic Crystals

An Interface Asic Of Quartz Vibratory Gyroscope With 0.8 Degrees/Hour Root Allan Variance

A Novel Resonant Accelerometer Based on Quartz on Silicon (Qos)

A Low-Noise HV Interface Circuit for MEMS Vibratory Gyroscope

Analysis of Parametric and Subharmonic Excitation in Push-Pull Driven Disk Resonator Gyroscopes

Development of an Effective Method to Reduce Mechanical Coupling Error in a Micro Quartz Tuning Fork Gyroscope

Technology of Sine-save Modulation and Demodulation Applied to Resonator Gyro

A 0.57°/h Bias Instability 0.067°/√h Angle Random Walk MEMS Gyroscope with CMOS Readout Circuit

Design and Simulation of Quartz Resonant Accelerometer

A 0.5 Degrees/H Bias Instability 0.067 Degrees/Root H Angle Random Walk Mems Gyroscope With Cmos Readout Circuit