Abstract:In this work, a three-dimensional finite element model of a newly structured high-speed continuous casting mold was established to study the heat transfer and solidification process of the billet shell. A complete billet shell, from the meniscus to the secondary cooling zone, was obtained through flame cutting. Using both simulations and test verification, detailed analyses were conducted on the temperature field distribution, thickness variation law, and cooling rate law of the billet shell within the mold, revealing its solidification behavior. Additionally, the effects of casting speed, molten steel superheat, and mold taper on the solidification behavior of the billet shell were discussed. Results showed that the simulation data were basically consistent with the test verification results. Within 200 mm from the meniscus, the heat dissipation accounted for three-quarters of the mold's total heat dissipation. The cooling rate at the corners of the billet shell was slightly higher than that at the sides. Between 200 mm and 400 mm from the meniscus, air gaps caused the temperature at the corners of the billet shell to rise. Afterwards, the whole billet shell eventually reached a similar the heat dissipation rates. The thickness of the billet shell increased exponentially within 110 mm from the curved meniscus, and from 110 mm to the exit of the mold, the thickness increased linearly but slowly. The effect of molten steel superheat within a range of 10 °C on billet shell solidification was relatively minor. Increasing the casting speed reduced the billet shell thickness and raised the billet shell surface temperature. However, increasing the taper of the mold had the opposite effect. Both adjustments shifted the gap formation position backward.

Numerical simulating study on the solidification process of continuous casting billet

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Numerical Simulation and Experiments Research on Secondary Cooling Process of Thick Slab Continuous Casting

Simulation and application of dynamic heat transfer model for improvement of continuous casting process

Numerical Simulation of the Fluid Flow, Heat Transfer, and Solidification in Ultrahigh Speed Continuous Casting Billet Mold

Study on solidification and heat transfer of billet shell in a new-structure high-speed continuous casting mold

Numerical Simulation of the Flow Field in an Ultrahigh-Speed Continuous Casting Billet Mold

Numerical Simulation on Multiple Physical Fields Behaviors in Billet Continuous Casting with Different Stirrer Positions

Numerical simulation of continuous casting process of different steel grades considering solidification and mixing of different steel grades

Applying of Real-time Heat Transfer and Solidification Model on the Dynamic Control System of Billet Continuous Casting

Numerical Simulation of Solidification Process in an SCR Wheel and Belt Continuous Caster

Numerical Simulation of Centerline Segregation in Continuous Casting Billet

Numerical Simulation of Inclusions Movement During Solidification of Continuous Cast Slab

Numerical Simulation of Solidification and Heat Transfer in Continuously Cast Bloom

Numerical simulation of shrinkage porosity defect in billet continuous casting

PROGRESS OF SOLIDIFICATION SIMULATION FOR CONTINUOUS CASTING

Numerical Simulation of Solute Transport Behavior During the Grade Transition of Round Billet Continuous Casting

Numerical Simulation of the Thermo-Mechanical Process for Beam Blank Continuous Casting

Application of Process Simulation Software on Secondary Cooling Optimization for Continuous Caster

Numerical analysis of the comprehensive effect of continuous casting process parameters on the continuous casting billet remelting

A coupled model on fluid flow, heat transfer and solidification in continuous casting mold