Abstract:To understand the nanomechanical properties of nano-grained (NG) Ti produced by combination of asymmetric and symmetric rolling, nanoindentation hardness (H(n)) and elastic modulus (E(n)) of different planes within the NG Ti specimens were measured using continuous stiffness measurement mode at room temperature. For comparison, the nanomechanical properties of the as-received hot-rolled coarse-grained (CG) Ti and ultrafine-grained (UFG) Ti with only asymmetric rolling process were also investigated. It was found that H(n) of the Ti samples increased significantly with the decrease of grain sizes, while E(n) exhibited a slight decrease as the grain sizes decreased from CG to NG regime. The increase of H(n) was expected to be caused by higher density of dislocations and finer grains attained by severer plastic deformation, while the slight decrease of E(n) was considered as a result of the increased density of lattice defects and volume fraction of the grain boundary atoms. Furthermore, the nanomechanical properties of different planes of the Ti specimen exhibited a little difference which can be expressed as H(n(RD-TD)) > H(n(N-RD)) > H(n(TD-ND)) and E(n(RD-TD)) > E(n(ND-RD)) > E(n(TD-ND)). These differences were ascribed to crystallographic textures formed by rolling deformation.

Indentation Stress Relaxation Behavior in As-Deposited and Rolling Nanocrystalline NiFe

Rolling Deformation Induced Reduction of Rate Sensitivity and Enhancement of Hardness in Nanocrystalline NiFe Alloys

Microstructural Evolution and Its Influence on Creep and Stress Relaxation in Nanocrystalline Ni

Tensile-relaxation Behavior of Electrodeposited Nanocrystalline Ni

Anomalous Strain Rate Sensitivity of Nanocrystalline Ni Induced by Rolling Deformation

Grain Orientation Induced Softening in Electrodeposited Gradient Nanostructured Nickel during Cold Rolling Deformation

A Crossover from Hardening to Softening in Nanocrystalline Ni by Annealing and Rolling

Deformation Induced Internal Friction Peaks in Nanocrystalline Nickel

Nanoindentation Hardness and Elastic Modulus of Nano-Grained Titanium Produced by Asymmetric and Symmetric Rolling

Ni/Ni3Al interface-dominated nanoindentation deformation and pop-in events

Creep behaviors of nanocrystalline copper after stress reduction under nanoindentation at ambient temperature

Solid Solution Effects on Hardness and Strain Rate Sensitivity of Nanocrystalline NiFe Alloy

Experimental And Modelling Investigations On Strain Rate Sensitivity Of An Electrodeposited 20nm Grain Sized Ni

Research on Effects of Rolling-Drawing Deformation on Performance of Cu-10Ni-1Fe-1Mn Alloy

Microstructure evolution of FeNiCr alloy induced by stress-oxidation coupling using high temperature nanoindentation

Indentation behavior of creep-feed grinding induced gradient microstructures in single crystal nickel-based superalloy

Effects of Surface Deep Rolling treatment on Mechanical Properties and Residual Stress Field in Pure Nickel

Effect of Strain Rate on Deformation Behavior of AlCoCrFeNi High-Entropy Alloy by Nanoindentation

Indentation Depth-Dependence of the Hardness of NiTi Shape Memory Alloy and Al Single Crystal: Phase Transition Versus Plasticity

Strain Rate Sensitivity and Activation Volume of Electrodeposited Nanocrystalline Ni and Ni-Co Alloys

Temperature-dependent strain rate sensitivity and activation volume of nanocrystalline Ni