Abstract:Creep behaviors of nanocrystalline (NC) Cu, Ni-20(wt.%)Fe and Ni with comparable grain sizes were examined by nanoindentation tests. It was showed that the creep behaviors depend on loading strain rate and stacking fault energy (SFE). At high loading strain rate, the initial creep rates of three NC materials are far higher than those predicted by the models of the Coble creep and the grain boundary sliding and are the highest and lowest for NC Cu and NC Ni, respectively, while that of NC Ni–20Fe lies between them due to their different SFE. At low loading strain rate, the creep behaviors do not exhibit significant difference among three NC materials. Our analysis revealed that grain boundary dislocation sources can be activated at high loading strain rate and the emitted dislocations from grain boundaries can be effectively stored in the loading regime, but cannot at low loading strain rate. The very high initial creep rates of three NC materials are attributed to the rapid absorptions of the stored dislocations in the loading regime and the newly nucleated dislocations in the holding regime. The higher creep rate of NC Cu as compared with those of NC Ni–20Fe and NC Ni arises from the higher density of the stored dislocations caused by the enhanced interactions of dislocations with twins and stacking faults due to its lower SFE.

Indentation Size Dependent Plastic Deformation of Nanocrystalline and Ultrafine Grain Cu Films at Nanoscale

The Influence Of Time, Temperature, And Grain Size On Indentation Creep In High-Purity Nanocrystalline And Ultrafine Grain Copper

Time Dependent Plasticity At Real Nanoscale Deformation

EFFECT OF GRAIN SIZE AND HOLDING LOAD ON NANOINDENTATION CREEP OF Cu FILM

Indentation size and loading strain rate dependent creep deformation of nanocrystalline Mo

Dislocation-mediated Creep Process in Nanocrystalline Cu

Dependence of strain rate sensitivity upon deformed microstructures in nanocrystalline Cu

Nanoindentation Response of Nanocrystalline Copper Via Molecular Dynamics: Grain-size Effect

Research on Deforming Mechanism of Nanocrystalline Cu Thin Film under Contact Deformation

Nanoindentation Creep Behavior and Its Relation to Activation Volume and Strain Rate Sensitivity of Nanocrystalline Cu

Size dependent mechanical properties of nanocrystalline Cu films

An Investigation of Nanoindentation Creep in Polycrystalline Cu Thin Film

Size Effects in Indentation Measurements of Zr–1Nb–0.05Cu Alloy

Depth Dependent Strain Rate Sensitivity and Inverse Indentation Size Effect of Hardness in Body-Centered Cubic Nanocrystalline Metals

Nanoindentation Creep Behavior of Cu–Zr Metallic Glass Films

High-Speed Creep Process Mediated by Rapid Dislocation Absorption in Nanocrystalline Cu

Indentation size effects on the creep behavior of nanocrystalline tetragonal Ta films

Thickness-Dependent Strain Rate Sensitivity of Nanolayers Via the Nanoindentation Technique

Indentation Scale Dependence of Tip-in Creep Behavior in Ni Thin Films

Effects of Loading Strain Rate and Stacking Fault Energy on Nanoindentation Creep Behaviors of Nanocrystalline Cu, Ni-20 Wt.%fe and Ni

Thickness and Grain Size Dependent Mechanical Properties of Cu Films Studied by Nanoindentation Tests