Abstract:Radiation safety standards today require comprehensive shielding protection schemes for all particle accelerators. The original shielding system of BJ-20 (BeiJing-20 MeV), the high-energy medical electron linac, was designed only for the 18 MeV level. And the dose caused by the lost electrons in the 270° bending magnet system was neglected. In this paper, the leakage dose of BJ-20 is carefully analyzed. The radiation leakage dose distribution of the photons coming from the accelerator head is obtained for energy levels of 6, 12, 14, and 18 MeV. The dose of the photoneutrons is especially analyzed for the 18 MeV level. The result gives that even neglecting the dose from the 270° bending magnet system, the shielding system is still not enough for the energy levels lower than 18 MeV. The radiation leakage produced by electrons that are lost in the 270° bending magnet system has been particularly studied. Using beam transport theory and Monte Carlo sampling methods, which have been combined in calculations, we have obtained the distribution of the energy, position, and direction of the lost electrons. These data were then further processed by the Monte Carlo N-particle (MCNP) code as input data. The results show that when the electron loss rate in the 270° bending magnet system is 13.5%, the radiation leakage dose of the photons generated by the lost electrons is 0.1% higher than that at the isocenter, and the corresponding relative leakage dose of the photoneutrons reaches 0.045% around an angle of 170° at 18 MeV level. Both of these parameters exceed radioprotection safety standards for medical accelerators. The original shielding design is therefore not suitable and is also incomplete since the radiation produced by the electrons being lost in the 270° bending magnet system was neglected and the leakage dose for the low-energy levels was not considered in the original design. Our calculations provide a very useful tool for further optimization and design improvement that will enable this radiation shielding to conform to present day safety standards.

Optimizing design for the maze exit of a 10-MeV electron irradiation accelerator

A COMPARISON OF THE CALCULATION METHODS OF THE MAZE SHIELDING DOSE

Radiation field calculation of ventilation duct for 3-MeV electron irradiation accelerator

Particular consideration on radiation shielding of a CyberKnife room

Dose Equivalent of Neutron and Induced Gamma Rays Near a Medical Accelerator

Physical Analysis of the Radiation Shielding for the Medical Accelerators

Dose reduction of scattered photons from concrete walls lined with lead: Implications for improvement in design of megavoltage radiation therapy facility mazes

STUDY ON THE SHIELDING AND DOSE RATE DISTRIBUTIONS OF THERAPEUTIC PROTON SYNCHROTRON ACCELERATOR BASED ON FLUKA

Optimal Shielding Structure Design for a Typical 14 MeV Neutron Source

Protection Design on Occupational Hazards in the Radiotherapy Place Reconstruction and Device Renewal

Optimize the Shielding of Therapy Head of 14mev Neutron Therapy System

Optimum design for the shielding protection of medical linear accelerator

Neutron dose distribution in the treatment room for an accelerator in the flattening filter-free mode

Efficient and Accurate Optimal Design Method for Radiation Shielding

Shielding optimization to reduce the radiation field in the accelerator systems of IFMIF-DONES

Photoneutron Radiation Field of Ducts in Barrier of 15 MV Medical Electron Accelerators

Study on Optimization Design of Compact and Lightweight Radiation Shielding Material for Vehicle-mounted Accelerator-driven D-D Neutron Source

Evaluating activation of the shielding walls of a treatment room using the Monte Carlo method

Study on Induced Radioactivity in Proton Therapy Accelerators

Optimization of Radiation Shielding Material Aiming at Compactness, Lightweight, and Low Activation for a Vehicle-Mounted Accelerator-Driven D-T Neutron Source

Shielding Research of Minitype Reference Radiation Device Based on Monte Carlo Simulation