Abstract:Scaled down thermal-hydraulic test facility is widely used in the nuclear reactor safety analysis. The wall stored energy is one of the common problem in a scaled down test facility, which will cause distortions in the simulation of the transients or local phenomena. For the natural-circulation mode in the Core Make-up Tank (CMT), the cold wall will work as heat sink and absorb heat from the heated water, and then has an influence in energy balance on the simulation of the prototype phenomena with scaled down test facility. In order to study the influence of the wall stored energy on the natural-circulation mode in the CMT test facility, this paper established the CMT test facility model with RELAP5/MOD 3.4, and studied the influence caused by the wall stored energy distortion. The simulation results show that the natural-circulation process in the CMT test facility can be divided into two stages: 1. Before the thermal stratification reaches the outlet, the natural-circulation flow rate decreases gradually. 2. Once the thermal stratification reaches the outlet, the natural-circulation flow rate has an apparent turning point and decreases faster. That is because the heated water reaches the outlet and fills the discharge line quickly, which reduces the density difference between the hot leg and cold leg, thus causing the natural-circulation flow rate decrease faster. Besides, before the turning point, the wall stored energy basically has no influence on the natural-circulation process, and the influence can be neglected in the design of test facility. However, after the turning point, the wall stored energy distortion results in a slower descent speed of natural circulation flow rate, which is not conservative. Therefore, we can conclude that the scaled down CMT test facility can only simulate the prototype properly and conduct the natural circulation simulation experiment before the thermal stratification reaches the exit, while afterwards, the simulation of the test facility won't be accurate and conservative.

CMT Scaling Analysis and Distortion Evaluation in Passive Integral Test Facility

Evaluation of Distortion of Wall Stored Energy in Core Make-Up Tank Test Facility

Steam condensation separate effect tests in core make-up tank

Technical Issues for the Fabrication of A Cn-Hccb-Tbm Based on Rafm Steel Clf-1

THE CMT SIMULATION ON THE LARGE IMPASSIVE PWR WITH RELAP 5

RELAP5 Validation for Core Makeup Tank Analysis Based on Separate Effect Tests

Non-Equilibrium Modeling and Simulation of Double Tank with Four Zones for CMT Water Supply System

Separate-effect drainage tests in a core make-up tank

Core Makeup Tank Behavior Investigation During ACME Integral Effect Tests

Stored Energy Analysis in the Scaled-Down Test Facilities

The Influence of the Wall Stored Energy on the Natural-Circulation Mode in the Core Make-Up Tank Test Facility

Assessment of Scaling Distortion in Condensation Film Heat Transfer

An Evaluation of Designed Passive Core Makeup Tank (CMT) for China Pressurized Reactor (CPR1000)

Scaling Analysis of the Pressurizer Surge Line in Nuclear Plant Integral Test Facilities

Scaling for Different Containment Passive Cooling Design under LOCA Conditions

Analysis on Working Pressure Selection of ACME Integral Test Facility

Results And Discussion On Scaling Analysis For The Nhr200-Ii Integral Test Facility Under Single Phase Natural Circulation

Investigation of Scale-Up Capability of RELAP5/MOD3 and Scaling Distortion in the IIST Facility Via Natural Circulation Experiments

Scaling analysis and design for PCS air flow path natural circulation

Scaling Analysis and Design for Integrated Nuclear Heating Reactor Ⅱ Major Loop Test Facility under Single Phase Natural Circulation

CFD analysis for full vessel upper plenum in Maanshan Nuclear Power Plant