RELAP5 Validation for Core Makeup Tank Analysis Based on Separate Effect Tests

Mingzhang Zhu,Huajian Chang,Han Wang,Qingzi Zhu,Yixuan Liu

DOI: https://doi.org/10.1016/j.nucengdes.2022.111967

IF: 1.7

2022-01-01

Nuclear Engineering and Design

Abstract:The RELAP5 code has been developed for best-estimate transient simulation of light water reactor coolant systems during accident and has been widely used in the field of nuclear thermal-hydraulics and safety analysis. The core make-up tank (CMT) is a crucial device of the passive core cooling system in the AP series pressurized water reactor nuclear power plants. Since the CMT not only provides full-pressure injection but also triggers auto depressurization system by its level signal during small-break loss of coolant accident. Therefore, it is necessary to carry out CMT separate effect tests to verify the feasibility and accuracy of RELAP5/MOD 3.4 to simulate CMT. The previous studies found that the lower version of the RELAP5 program has problems in simulating CMT, and the applicability of the latest RELAP5/ MOD3.4 has not been evaluated. In this paper, a CMT separate effect test facility were presented and then RELAP5/MOD 3.4 was used to establish a CMT test bench model to evaluate the applicability, and obtain the general rules and methods of RELAP5/MOD 3.4 to simulate CMT. It's found that RELAP5/MOD 3.4 can accurately simulate most of the CMT operating conditions. However, large uncertainty is expected in the simulation of delayed time and the flowrate of delayed drainage stage is not affected by the heat transfer coefficient of steam direct contact condensation. The simulation of delay time depends on experimental data and the CMT delayed drainage experiment cannot verify the accuracy of the RELAP5/MOD 3.4 direct contact condensation model.