Abstract:Heat transfer in a latent heat energy storage unit is not intensive and is primarily determined by the low thermal diffusivity of phase change material. Then one may think even weak natural convection in the unit can significantly enhance heat transfer, and the role of natural convection in the unit is of great importance. It is very difficult to split out the role of natural convection from the experimental results. This paper investigates the role of natural convection in a vertically posited shell and tube latent heat energy storage unit by employing one model considering natural convection and the other model without considering natural convection. A critical vertical annular layer thickness and convection impact factor are proposed to determine the occurrence of natural convection and the effect of natural convection on the charging process. The results indicate that the critical vertical annular layer thickness to judge the occurrence of natural convection is 1.04 mm for the vertical unit analyzed in the present paper. The unit considering natural convection increases the time needed to complete the charging process by 46 % compared to the unit without considering natural convection, indicating that natural convection has negative effect on heat transfer, despite the gradual strengthening of natural convection in the vertical unit. The main reason is that natural convection brings phase change material with high temperature to region downstream the tube, resulting in a reduction of the temperature gradient on the tube wall downstream and the average heat flux normal to the tube surface. This might be indicated by that the convection impact factor is greater than 1 before 660 s, and is less than 1 after 660 s. The melting time increase caused by natural convection is respectively 39 %, 42 % and 46 % for w in = 0.013, 0.13 and 0.28 m/s, and 46 %, 51 % and 60 % for θ f.in = 5, 10 and 20 K. This demonstrates that the negative effect of natural convection is even more noticeable at the higher flow velocities and inlet temperatures. But the existence of negative effect of the natural convection is independent of the heat transfer fluid inlet velocity and temperature.

The Influence of the Wall Stored Energy on the Natural-Circulation Mode in the Core Make-Up Tank Test Facility

Evaluation of Distortion of Wall Stored Energy in Core Make-Up Tank Test Facility

Steam condensation separate effect tests in core make-up tank

Stored Energy Analysis in the Scaled-Down Test Facilities

Separate-effect drainage tests in a core make-up tank

RELAP5 Validation for Core Makeup Tank Analysis Based on Separate Effect Tests

Thermal Analysis on NAC-STC Spent Fuel Transport Cask under Different Transport Conditions

CMT Scaling Analysis and Distortion Evaluation in Passive Integral Test Facility

CFD Investigation of the Cold Wall Effect on CHF in a 5 × 5 Rod Bundle for PWRs

Theoretical And Experimental Study On Natural Circulation Relevant To Nuclear Heating Reactor

Cfd Simulation of Natural Ventilation Performance of the Interim Region in Spent Fuel Dry-Storage System of Htr-Pm

A Numerical Investigation Of Natural Convection Heat Transfer In Horizontal Spent-Fuel Storage Cask

The negative effect of natural convection in a vertical shell and tube latent heat energy storage unit

CFD simulation of the thermal-hydraulic characteristics within spent fuel storage pool

Analysis of the Effect of Thermal Stratification on the Natural Circulation Decay Heat Removal of Sodium-Cooled Fast Reactor

Numerical Investigation on the Thermal Stratification in a Pressurizer Surge Line

Experimental Investigation on Heat Transfer Characteristics in a Safety Injection Nozzle Component in PWR

Preliminary Analysis of Flow and Heat Transfer Characteristics of WCSB Blanket Module First wall

Preliminary Applications of CFD Methodology on Analysis of the Single-Phase Laminar Natural Circulation under Swing Conditions

An Integrated Thermal and Mechanical Performance Analysis of Effect of Cold Molten Salt Temperature for Thermocline Tank

Flow distribution analysis of partial model for WCSB blanket module