Abstract:Passive safety systems are widely used in the advanced nuclear reactors, such as AP1000 and CAP1400. As an important component in the passive safety system, the core make-up tank (CMT) plays a key role for the safety injection and the core decay heat removal. Although the structure of the CMT system is simple, it involves many thermal-hydraulic phenomena, most of which significantly impact the peak temperature of the fuel cladding and the liquid level of the core. Since the CMT not only provides full-pressure injection but also triggers the auto depressurization system by its liquid level signal during small-break loss of coolant accident (SBLOCA), its thermal hydraulic behaviors significantly affect the performance of the passive core cooling system (PXS). Therefore, separate effect tests are inevitable to verify the feasibility of CMT applied to passive safety and injection systems and to study its operating characteristics. In this work, a separate-effect CMT test facility was designed and constructed. Experiments were performed to investigate the CMT's thermal hydraulic characteristics under the effects of system pressure, steam condensation, and flow friction. The study found that the delay drainage phenomenon is the result of a pressure balance between the pipe line and the gravity head. Whether delayed drainage occurs depends on the degree of subcooling of the fluid at the top of the CMT. The flowrate is not affected by the heat transfer coefficient of steam direct contact condensation. The flow friction of the drainage pipeline has no effect on the delayed drainage process, but has a great influence on the gravity drainage process.

Core Makeup Tank Behavior Investigation During ACME Integral Effect Tests

Steady-state Simulation of Core-Annulus Flow in a Circulating Fluidized Bed (CFB) Riser

Steam condensation separate effect tests in core make-up tank

CMT Scaling Analysis and Distortion Evaluation in Passive Integral Test Facility

Separate-effect drainage tests in a core make-up tank

RELAP5 Validation for Core Makeup Tank Analysis Based on Separate Effect Tests

CMT and PBL study in the high-pressure phase on the advance core-cooling mechanism experiment with RELAP 5

Experimental and Numerical Investigation on the Thermal and Mechanical Behaviours of Thermal Barrier Coatings Exposed to CMAS Corrosion

THE CMT SIMULATION ON THE LARGE IMPASSIVE PWR WITH RELAP 5

Overview of Experimental Results on the HL-2A Tokamak

Experimental and Simulation Analysis of the Evolution of Residual Stress Due to Expansion Via CMAS Infiltration in Thermal Barrier Coatings

Interfacial Stresses of Thermal Barrier Coating with Film Cooling Holes Induced by CMAS Infiltration

Numerical Research on Thermal Mixing Characteristics in a 45-Degree T-junction for Two-Phase Stratified Flow During the Emergency Core Cooling Safety Injection

Numerical Assessment of Thermal Insulation and Stress Responses in Film-Cooled Turbine Vane Thermal Barrier Coatings under CMAS Deposition Conditions

Numerical modelling of CMAS infiltration and dimensionless numbers of anti-infiltration designs of thermal barrier coatings

Non-Equilibrium Modeling and Simulation of Double Tank with Four Zones for CMT Water Supply System

A comprehensive parametric study on integrated thermal and mechanical performances of molten-salt-based thermocline tank

Numerical Study on Effect of Non-uniform CMAS Penetration on TGO Growth and Interface Stress Behavior of APS TBCs

Numerical Analysis of Cmas Penetration Induced Interfacial Delamination of Transversely Isotropic Ceramic Coat in Thermal Barrier Coating System

Experimental Investigation and Model Analysis on Upper Plenum Entrainment in AP1000

Stress Evaluation of TBCs with Inclined Film-Cooling Hole Considering CMAS Penetration-Induced Change of Thermo-Mechanical Properties